Your cart is empty.
Your cart is empty. Fitment:
A&E 8500 Awnings
A&E 9000 Awnings
Installation:
1.Remove the old slider catch
Extend the awning and insert a small flat bladed screwdriver into the seam between the back and front of the catch. Pry the back off and remove the slider catch.
2.Install the new slider catch
Insert the new Slider Catch through the hole in the main arm from the front. Then insert the lip of the back into the lower ledge Place the spring between the back of the slider catch and the Main Arm Snap the back of the slider into the front piece being careful not to allow the spring to come out.
Jenny
Reviewed in the United States on February 5, 2025
Easy to install. Worked as expected.
Customer
Reviewed in the United States on June 9, 2024
Easy installation
Tom S
Reviewed in the United States on June 27, 2024
they work
Customer
Reviewed in the United States on June 13, 2024
perfect replacement for my awning arms
Andrew Laird
Reviewed in the United States on May 6, 2024
Instructions were easy to follow. Works great!
Terry Peterson
Reviewed in the United States on December 6, 2024
Works well
John Cummings
Reviewed in the United States on July 27, 2023
Simple install. Works good.
Did
Reviewed in the United States on July 22, 2023
Awning
Melissa
Reviewed in Canada on August 15, 2022
We were disappointed when we bought an RV and realized the manual awning bar wouldn’t stay locked at the top. We bought this, installed it in literally 10 seconds and our awning is fixed.
Francoise
Reviewed in Canada on July 12, 2022
Pour barre de retenu sur auvent de VR. en b/o dans quelques détaillant. Un peu trop cher pour si peu de plastique
Recommended Products
