Giampiero Bono
Reviewed in Spain on March 23, 2025
El mango flotante cumple su función principal: mantiene la GoPro a flote sin problemas, incluso en movimiento. Es ligero, cómodo de sujetar y muy útil para grabaciones en el agua.Sin embargo, le doy 4 estrellas porque entra agua en el compartimento interior, lo cual hace que no sirva para guardar objetos pequeños o mantener cosas secas dentro. No afecta al funcionamiento, pero habría estado bien que sellara un poco mejor.Por lo demás, buen accesorio por el precio.
Tucko The Clown
Reviewed in the United States on March 15, 2025
Good, but the handle leaks a lot.
V.
Reviewed in Italy on September 4, 2024
Fa il suo dovere
Kunde
Reviewed in Germany on August 30, 2024
Top schnelle Lieferung wie beschrieben. Daumen hoch 👍
Hector
Reviewed in the United States on August 28, 2024
Is simple but it does the job, for the price is AWESOME
Lenaerts Alan
Reviewed in Belgium on October 3, 2024
Flote parfaitement mais attention l'eau penetre dans le manche donc éviter de mettre quoi que ce soit de fragile dedans
Kim H
Reviewed in the United States on January 2, 2024
This housing complety flooded my brand new camera. I'm super pissed! I have lots of experience with these and have never had this happen. They need to be covering the cost of a new camera also.
tony
Reviewed in France on January 11, 2024
pas encore utilisé et qualité juste à la limite dommage
JennaSys
Reviewed in the United States on January 29, 2023
For the price, I wasn't really expecting much from this other than for to be able to hold a camera securely. For my use, I did not need it to be waterproof. And for that purpose it is fine. The rubber shell around the molded handle is a little loose, but not to the point of being a problem (at least not immediately).For those that need this handle to be reasonably waterproof, there are two things I see than could improve on that likelihood. The seal on the handle is a flat rubber washer that sits on the bottom surface of the handle. I noticed that there are two burrs on the handle left over from the plastic molding process, that if left there, will likely cause a leak. If you trim or sand those down so they are flat, you will get a better seal with the flat washer. The second thing I noticed it that the bottom cap also has what looks to be an unused O-ring groove towards the end that sits up inside the handle. If you were to put an appropriately sized O-ring on there, you could get a 2nd seal that would again decrease the likelihood of water getting in. If I was going to use this handle in water, I would do both of these things.
T. Creek
Reviewed in the United States on September 2, 2022
It's light and it floats even with a waterproof Olympus Stylus hanging off of it. I'm not sure how long water would stay out of the handle given the construction of the threads and the thinness of the gasket. It's a $7 action camera handle - adjust your expectations.