Your cart is empty.
Your cart is empty. Szliyands digital display current indicator uses LED light-emitting chip as the light source, which has the characteristics of long service life, low energy consumption, small size and light weight. It is a substitute for various incandescent and neon lamps of the XD type. The lampshade is made of high-strength polycarbonate, with good impact resistance, built-in spiral wire and safe and convenient terminals. This series of indicators is suitable for signal indications, warning signals, accident signals and other signals in industries such as electricity, telecommunications, machine tools, ships, textiles, printing and mining machinery.
Parameters:
Voltage range: AC50~500V
Measuring range: 0~100A
Color:Green ,
Package includes: 1 X digital display current indicator light
Kaos HQ
Reviewed in the United States on March 9, 2025
It does not work. Also I didn’t realize you are required to run the main power through the sensor. Anyway this one is bad and looks and feels cheap.
Francisco D
Reviewed in the United States on January 4, 2025
It is very practical avoiding to use a manual hook-on or amperimeter.
Shattuck
Reviewed in the United States on June 27, 2024
The media could not be loaded.
omar hernandez
Reviewed in the United States on September 17, 2023
it is not a good product it does not work
Skyhawk
Reviewed in the United States on November 20, 2022
I ended up converting the current indicator to a Watt meter. I wanted to measure lower amperage so I could have run my load wire through the current sensor 10 times to get a number 10 times bigger. Problem with that is the fixed decimal point would be incorrect.I realized that I could wind the wire through the current transformer 12 times and that would work out perfectly for Watts (when using 120VAC) if I could just get rid of the decimal point. Some black paint solved that problem. Using a plastic tool you can carefully pry off the red cover from the top. This accomplished I painted over the decimal point.I installed a 5 amp fuse in front of the whole thing and utilized 16 AWG, 300 Volt wire. My modification ONLY works because I am protecting it with a fuse and I'm also measuring relatively low currents. Don't try this if you want to use a lot of power. Make sure that you use a fuse holder rated for the voltage you're going to use. I used a Littlefuse 01500603Z from Mouser Electronics. Remember, the fuse should be the first thing in the circuit to protect everything down stream.Regardless, this is a nice little meter that's easy to install in a round hole.
Recommended Products
$129.00
$ 60 .99 $60.99