Your cart is empty.
Your cart is empty.Dorman 05177 Spindle Nut
Randy
Reviewed in the United States on January 5, 2021
Great Replacement for front axles...2008 Chevy Silverado 4WD.
PoppaJ
Reviewed in the United States on April 12, 2021
Great value for the money
Kyle
Reviewed in Canada on December 7, 2020
I didn't realize when I ordered this that my original axle nut had a washer attached to it, where as this one is just the nut. The washer is not removable or I would have simply reused it. I went ahead and installed it anyways with my new wheel hubs. The fit and installation was still exact, no issues. Installed on 2013 GMC Terrain.
AD
Reviewed in the United States on October 20, 2020
for my application, the factory spindle nut requires a 30 mm socket; this (Dorman 05177) is the recommended replacement for my application; 2010 chevy cobalt 2.2L (LAP). oddly enough, it requires a 36 mm socket to install. upon removing the old spindle nut, this part is clearly too large; needless to say, the amazon vehicle fitment guide is incorrect.
Richard Berry
Reviewed in the United States on April 28, 2019
Not exact match to original equipment. Threads are the same as original nut but the hex size is larger. Don't know the actual metric socket size because I used a slightly oversized SAE socket that I had on hand. Anyone with a limited tool box is gonna have to by a new metric socket.
RSL1
Reviewed in the United States on August 17, 2018
Always install a new lock nut on the axle shaft spindle. Clean all grease off axle threads. Don't reuse the old nut. Be sure to look up the torque spec. for that vehicle and torque the nut without any weight on the tire. On my 4wd this nut preloads the front wheel bearings. To tight or to loose the bearings will fail. Vehicle weight on bearings before torque can push the grease seals out and bearings will fail. While not all vehicles are the same, look up or consider these tips.
Chad Lee
Reviewed in the United States on April 11, 2018
Sometimes you just got to get a nut
L.Y.
Reviewed in the United States on December 31, 2015
They fit, however, original nuts are 35mm, these are 36mm.The quality is horrible, threads basically fell apart on install. Why risk your life over 6 bucks.??
BPD
Reviewed in the United States on June 8, 2013
Was doing the hub and bought this item...excellent rpoduct although it is 36mm and the part that came off was 35mm and I did not have a socket. So this hit the junk pile for next time. was ready to replace
Recommended Products
