Your cart is empty.
Your cart is empty.Dorman offers a variety of Door Lock Strikers for a range of applications. All our Door Lock Strikers are constructed of high-quality materials for long-lasting service.
Lowell Dewey
Reviewed in the United States on September 9, 2024
Just followed YouTube tutorial, adjusted location, now my ‘78 Lincoln door closes tight and pops open like new.
Rob sweet
Reviewed in the United States on July 1, 2024
Fast, on time shipping. Good part!
J Lowe
Reviewed in the United States on September 7, 2023
Exactly as advertised. I installed it on the driver's door of my 78 Mercury Cougar XR7 and no more door rattle
Casey H
Reviewed in the United States on March 1, 2022
Used these on my 1981 Ford F 100. Previously purchased another set that was supposed to fit the truck, but the bushing were too think. Amazon and auto parts stores will tell these don't fit and 81-86, but they fit perfectly. When you install them, snug them up but don't tighten, then close the door and then tighten it up. The door closing will line up the striker bolt to the correct position.
Customer
Reviewed in Canada on December 30, 2022
Worked as described on my 1979 ford f250.
Sam
Reviewed in the United States on December 20, 2022
Fix just like the original. Door shuts perfectly! Definitely buy these again if needed and would refer them to anyone. Great product!!!
Daryl
Reviewed in Canada on November 30, 2022
The door strike worked except the plastic was too thick and couldn't open my door after installing. I had to put the plastic sleeve in a vise and sand it down a bit. Once I did that I set it back to original position I scribed it worked great
kristopher
Reviewed in Canada on April 22, 2022
Works great, fits perfectly, well made.
Kendo
Reviewed in the United States on July 30, 2021
Dormans door striker bolts always go right on and work for a long time. Mark with marker or tape around the old one before removing. This will give you a guide for the new install. This tip saves a lot of time and frustration. The bolt does not center itself. Once in, your rattle is gone.
Maggie Hall
Reviewed in the United States on March 29, 2021
I installed these on my 78 Ford 250 pickup. The original sleeves had disintegrated. No problem in installation, but the sleeves were a about 1/16th to thick. I had to file them down where the latch hit. It took me 4 tries before I got it right. The drivers side worked well with no filing, but the passenger took some work. Other than that, they worked fine.
Customer
Reviewed in Canada on August 16, 2019
it was good to put on
paul
Reviewed in Canada on July 5, 2019
good fit and fast del
GlevumGuy.
Reviewed in the United States on January 31, 2015
this 38421 bolt is an exact replica as far as i can tell of the original bolts on my 86 crown vic. and i have replaced 3 of them due to the bushes breaking up. the 'recommendation' though, at the top of the amazon web page, advises the 38421 bolt will NOT fit my car. recommended instead is the 38448 which seems to be the same bolt but there is also a steel flange attached which wasn't on my originals, so i don't know what's going on here. the bushing as is locks up when the bolt is seated so i used a rough sanding paper to take a little off and now the bushing rotates when installed.
Recommended Products
