Your cart is empty.
Your cart is empty.This control arm ball bushing is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Lexus GS300: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005] - [Lexus GS400: 1998, 1999, 2000] - [Lexus GS430: 2001, 2002, 2003, 2004, 2005] - [Lexus IS300: 2001, 2002, 2003, 2004, 2005] - [Lexus SC430: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010]
Victor De Sousa
Reviewed in Canada on July 7, 2024
Delivery was on time
Ted
Reviewed in the United States on July 2, 2024
Removed old ones and pressed these in ,only took about an hour for both
Joshua S.
Reviewed in the United States on September 28, 2023
Part looks and feels durable. Will install soon on my 2003 Lexus is200.
Jose Luis cabral Ramirez
Reviewed in the United States on August 17, 2022
Excelente material, con esto se elimino el rechinido de la parte de atrás de mi carro
filipp gleyzer
Reviewed in the United States on July 25, 2022
Yes requires pressing but very good repair
Mr. Tan
Reviewed in Canada on May 17, 2022
Fixed the squeaking issue, Dorman has never disappointed
Alehouse327
Reviewed in the United States on June 8, 2021
Took longer than expected to replace, but that is not the fault of the part. The original bushing pressed out easily. I then needed to fabricate a ring to press the new bushing in. I struggled for an hour trying to get the new bushing to go in straight. If it is not straight it will not self correct. Once straight it slides in.
Customer
Reviewed in the United States on April 26, 2021
Makes a big difference over the worn out factory ones on my 04' GS430. I had the classic GS rear suspension squeak where the axle carrier bushing would creak on bumps and dips in the road. Some parts catalogs call this the "lower control arm bushing". No more suspension noise or clunking coming from the rear. Exact fit to O.E. specs pressed in very easily with a rented ball joint press. A very small part that takes about 2 hours to replace on both sides but makes a big difference.
Mekhel
Reviewed in Canada on July 6, 2019
Would have fit my car perfectly fine but returned it cause I didn’t need. Found my other polyurethane bushings.
Vikash S.
Reviewed in the United States on May 2, 2019
As seller says, very durable
Dwayne
Reviewed in the United States on January 20, 2019
Work well on my 2001 toyota altezza rs200Good quality too
Recommended Products
