Your cart is empty.
Your cart is empty.This direct replacement harmonic balancer features a stress-resistant rubber bond to properly absorb engine vibration. Stringent standards help ensure excellent tensile and impact strength for greater durability. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Acura RSX: 2005, 2006] - [Acura TSX: 2004, 2005, 2006, 2007, 2008] - [Honda Accord: 2003, 2004, 2005] - [Honda Civic: 2002, 2003, 2004, 2005] - [Honda CR-V: 2002, 2003, 2004, 2005, 2006] - [Honda Element: 2003, 2004, 2005, 2006]
Adam
Reviewed in the United States on February 24, 2025
Fiy my 08 civic si but had to get a 66 inch belt as the pulley is slightly bigger than the stock one
Paul Kostares
Reviewed in the United States on June 15, 2024
working perfectly on my 04 crv
Patrick
Reviewed in the United States on October 2, 2023
Packaging had holes in it, and the part had been clearly dropped or hit very hard based on the damage in pictures.
louis dunseith
Reviewed in Canada on April 24, 2022
Perfect fit and finish on my 02 crv. Nothing bad to say.
Luilou4373
Reviewed in the United States on March 17, 2021
Arrived pretty quick but only to find out that there is a gouge that will cause the main seal to wear quickly or fail and leak oil. That’s one reason why I ordered a new balancer was because I was changing the seal. Poor handling and storage what can I say...
Kevin Barillas
Reviewed in the United States on March 6, 2018
It was perfect for my Honda crv 2003. The only recommendation is to clean the screw of the pulley with a wire brush, they should clean all around and lubricate everything with grease. My screw was heated with a torch and I used a torque multiplier to loosen it without using a lot of effort.
Roll01
Reviewed in Canada on November 18, 2018
Installed on 2005 CRV. Fit perfectly.
Jose Madera
Reviewed in the United States on March 25, 2016
This does not seem to be the original Type S pulley for an Acura RSX. It is about 6 .5 inches and the original is about 5 3/8, that was the only issue i have found. It seems built similar to the original but like I said it is not the right fit like Amazon says it is.
Jong Moon Choi
Reviewed in the United States on April 15, 2015
Fitted well on my CRV2003(2.4). the pulley was removed by very large air impact. I strongly recommand to replace the oil seal together underneath of the harmonic balancer. when I took off the pulley, the seal was leaking because the engine is 12 years old. the seal is cheap($5~$10). save your time!!
MJ
Reviewed in the United States on August 7, 2014
Perfect fit on a 2003 Accord built in Japan.
Recommended Products