Your cart is empty.
Your cart is empty.Rob
Reviewed in Canada on March 12, 2025
i would give it a zero if i couldwould not clip into placetoo much glue on itremoved the excess gluetried to fit it againstill wont clip into place2 clips brokeended up holding it in place with duct tapewell at least it works lol
Dr G
Reviewed in the United States on July 7, 2024
Not quite there
Shannon Blankenship
Reviewed in the United States on September 7, 2023
It worked as it should on my 2008 Buick Enclave
yann keays
Reviewed in Canada on September 23, 2023
Efficace et rapide.
evans zander
Reviewed in the United States on May 4, 2023
fit perfect
WiseBuyer
Reviewed in the United States on May 26, 2023
Nothing super cool or fancy here, but works as intended, looks exactly like the original, and fits fine after removing the excess clue around the edges and seal. Without removing that extra glue, it wouldn't seat properly in the opening on the car. It's clear from the picture, but this requires solder or crimp connections as it's not a plug-in item. You should be able to replace it on a 2008 Cadillac CTS my simply using a small screwdriver to pop off the old one, pull out some excess wire, solder on the new (wire colors match the original), remove excess glue, and pop back in. Note -- on the CTS, the button only works if the key is near the rear bumper. It's doesn't work just because the car is "unlocked" like other cars I've experienced.
K&B Install Remodel LLC
Reviewed in the United States on December 9, 2021
Item was not an exact fit, when I try to use it it falls out of the opening, and water is still getting into the trunk
Recommended Products
$35.49
$ 16 .99 $16.99