Your cart is empty.
Your cart is empty.This engine camshaft position sensor is designed to match the fit and function of an original sensor to help ensure the engine control unit receives proper inputs when an original sensor has failed from heat or internal component damage. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chrysler Grand Voyager: 2000] - [Chrysler Pacifica: 2005, 2006, 2007] - [Chrysler Town & Country: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007] - [Chrysler Voyager: 2000, 2001, 2002, 2003] - [Dodge Caravan: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007] - [Dodge Grand Caravan: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007] - [Jeep Wrangler: 2007] - [Plymouth Grand Voyager: 1998, 1999, 2000] - [Plymouth Voyager: 1998, 1999, 2000]
Joel D.
Reviewed in the United States on June 5, 2023
Went in eas just had to remove front motor mount
Bandar•••
Reviewed in Saudi Arabia on October 5, 2021
قطعه ممتازه
Abracadabra
Reviewed in the United States on July 16, 2020
Do not remove the colored plastic/paper sticker/spacer from the end of the sensor. It is there to set proper tone-ring to sensor gap. The spacer will disintegrate gradually after the engine starts. Make sure you have a tone-ring tooth facing the sensor hole. Push the sensor in until it seats, lock it down and connect the electrical pigtail. You're done.
Bill Grissom
Reviewed in the United States on May 31, 2020
I wanted to buy because the cheap Chinese one (AUX) I recently installed causes the engine to die erratically, with "bad camshaft circuit" code. But, Amazon won't ship to my CA address. My guess is that Dorman didn't file the routine Prop 56 paperwork (stupid cancer warning). I trust Dorman products and will pay more for them, but now I question since they are apparently negligent. The Chinese products file the paperwork, so I'll have to try another.
Geoffrey Bungle
Reviewed in the United States on March 7, 2020
This part solved my issue and was cheaper than any local store. The part has been in the car for a couple months with no issues.
Jesus ernesto reyes paez
Reviewed in Canada on December 10, 2019
Bonne qualite
Robert RosenHanst
Reviewed in the United States on October 13, 2019
Car dropped dead in driveway no spark. I replace the crank sensor first as it is "easier" to get to- with no success.After much reading and frustration replaced the cam position sensor. Minor pain in the ass to replace but no big deal. Van started and everything back to normal. It actually seems a bit more peppy with the new sensor.250,000 miles on van.
Richard H. Waggy
Reviewed in the United States on August 8, 2015
Works fine, but it proved the old one worked also.
Recommended Products
