Your cart is empty.
Your cart is empty.This throttle position sensor is designed to match the fit and function of the original sensor on specified vehicles, and is engineered for durability and reliable performance. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Acura RSX: 2002, 2003, 2004, 2005, 2006] - [Honda Civic: 2001, 2002, 2003, 2004, 2005] - [Honda CR-V: 2002, 2003, 2004, 2005, 2006]
Nice show for kids and better price
Reviewed in Canada on September 23, 2024
I just installed this TPS from dermol. So far so good. Just heads-up, if you don't have Multimeter tool . Just mark where your old one is sitting than make sure to set the new one at correcter marker.
Jason P.
Reviewed in the United States on October 20, 2024
Worked well and fixed my problem
K. Trinh
Reviewed in the United States on August 10, 2023
Throttle Position Sensor Replacement (P 0122) Use Dremel to cut slot to remove those two factories cut off head bolts. Also need a back probe and multimeter to calibrate the TPS. Fit on 2004 -2005 Honda Civic Lx.
raul
Reviewed in the United States on February 17, 2023
Just follow the instructions. It was so easy , my car running like brand New. Thanks , excelent quality
Lpower
Reviewed in the United States on August 1, 2022
Spring is sprung in wrong direction don’t buy for the CRV, in the older civic direction
genaro ortiz
Reviewed in the United States on May 13, 2022
Do not bring the screws like in the picture very bad.
Customer
Reviewed in Canada on January 4, 2021
Used on 2005 Acura RSX fixed the issue causing MILI would get a mechanic to install unless you know what your doing
Mr. T
Reviewed in the United States on March 11, 2020
O.K. it's a bear to get to it so you can make the swap but stick with it as the result brings you back to "like new" performance. Dorman makes a quality part and you can trust and afford it! Allen head fasteners are much better for the part as space is too tight to deal with even a stubby phillips screwdriver. Much easier to install and adjust with an allen wrench.
Alex M
Reviewed in Canada on October 28, 2019
Payed to get it installed due to laziness of doing it myself , but it works ! I already see the difference in mileage I get on gas. And car finally doesn’t feel funny when driving. Hope it last!
Tradesman
Reviewed in Canada on January 18, 2019
Installed on my daughters 2003 Civic. In the colder months, the car had poor fuel economy, irratic idle and terrible transmission shifting. Job was easier than expected. After removing air filter and box, Remove the 4 bolts holding the throttle body to the intake, to access the TPS. Use a dremel tool with cutting disc to grind a slot in each of the EXISTING screws that hold the original HONDA TPS in place. DONT GRIND TOO MUCH. Install NEW TPS, Set up the voltages as per the instructions and VOILA! Use proper torque specs when replacing TPS AND throttle body. Fixed the irratic revving and poor shifting. No complaints yet!
James G
Reviewed in Canada on July 10, 2018
Working fine. It is difficult to install without removing the throttle body. Recommend to pay close attention to its position when removing and to install the new one exactly the same.
KRB
Reviewed in the United States on November 3, 2018
Bought this to replace the TPS in my 2004 Honda Civic. Honda wants you to purchase an entire throttle body for 1200 plus labor due to the OEM torque snap bolts (shame on you honda). This was 28.00 and came with all the instructions to replace and adjust. You will need a dremel, a digital multimeter, and Fluke TP88 Rigid Back Probe Pin Set, 2" Length or equivalent. I partially removed the throttle body and covered the intake with a large rag. Cut a slot in the bolts with the dremel and remove with a flat tipped screw driver. A stubby #2 phillips will assist with installing the new bolts (unless you completely remove the throttle body). Upon installation, snug the new bolts, and adjust as the included instructions instruct :). Great product! This also cleared up hard shifting...which was making us worry about a transmission issue...very happy for companies like this!
Customer
Reviewed in the United States on January 23, 2018
Installed on 04 Civic Ex, perfect fit and works. Easy to calibrate as long as you have a multimeter. Easiest way to install would be to remove throttle body but i didn’t want to at first and ended up having a hard time tightening the bolts due to lack of space. Took the throttle body off to clean it and calibrate the TPS, definitely a good deal for those of us who like to do our own work on our vehicles. Hopefully it holds up
Recommended Products
