Your cart is empty.
Your cart is empty.
Dear Customer,
This is a bypass module for car Alarm remote engine Start & push start button for vehicle with chip immobilizer in factory OEM key fob.When you use remote start your car or use push start button to start the car you need to install this bypass module to bypass the chip immobilizer.
If there is no chip immobilizer in your factory OEM key fob, you no need to buy this bypass module.
When installation this item, you need to release/unlock/remove the steering wheel lock in your car.
How to release/unlock/remove steering wheel lock?
Method 1:
1) Copy a car key of your factory OEM car blank key;
2) Insert the duplicated car key into the key socket and turn it to ON position;
3) Break the outside part of the duplicated on the key socket and keep it on the ON position; leave 1-2mm on the outside of key socket.
We sincerely recommend you to install it by a professional alarm installer or trained staff.
Packing list
Bypass module x1
2pin wire x1
Wiring diagram x1
Isaias A.
Reviewed in Mexico on April 12, 2023
La comodidad para arrancar el vehículo tanto con el botón de arranque como también con el control remoto muy recomendable
Connor Woods
Reviewed in the United States on August 22, 2021
Immobilizer bypass didn’t end up working for my 2009 Honda Civic Si, Had to take the original key apart and remove the transponder chip.Ended up shoving the chip between the ignition key way plastic as shown in the photos at the end of my finger, and that works fine. Save your money, think smarter not harder.
Romgrel
Reviewed in the United States on March 21, 2020
I'd give this 0 stars if I could. I wasted $9 on this as it was recommended as a necessity to install the button start in a 2007 Tacoma, however all it did was cause problems as the alarm was continuously going off and the doors were locked shut on me at one point and the vehicle turned shut down on me on the highway going about 65mph, luckily I was in the middle lane and was able to stop. After removal, the vehicle worked well and started fine with no problems with only the button start installed.
richard quinonez
Reviewed in the United States on February 9, 2020
Good
Dave archer
Reviewed in the United Kingdom on February 4, 2020
Excellent
Dakota
Reviewed in the United States on November 11, 2020
Does what its supposed to. Bypasses the Chip Immobilizer on my 2011 Jeep Patriot so I can Remote Start and Start with Push Button System.The wires are INCREDIBLY thin, wish they would've used some thicker gauge wires, but oh well....it works for my vehicle
ねこさん
Reviewed in Japan on October 2, 2020
間違いなく接続するが作動せず。不良品か。ちなみに二個買いましたが他の車種も同じく作動せず。捨てました。
Avi Misshell
Reviewed in the United States on February 24, 2019
Simple and working great
Joseph Godfrey Sheffu
Reviewed in the United States on November 13, 2019
great item, great service
Media Man
Reviewed in the United Kingdom on May 4, 2018
Unfortunately this item did not work, so had to go another direction.
Teclo
Reviewed in the United States on June 5, 2016
Too simple to be true i couldn't believe it i thought that there was more to it than just putting in the key and stringing the wire around the ignition cylinder. no wire to attach to the actual alarm system simple simple Great guys COOL
Alx Benjamin
Reviewed in the United States on February 16, 2016
Turns out I didnt need to use this, but made good use of it on my buddys car.works just fine if installed correctly
Recommended Products
