Your cart is empty.
Your cart is empty.Product Description
Steven R.
Reviewed in the United States on May 23, 2024
The media could not be loaded.
D Mill
Reviewed in the United States on August 12, 2023
I read the previous reviews, per customer's review for a 2007 Polaris Ranger 700 I decided to purchase the product.The product was physically a direct replacement for my 700.However the OEM TPS read 4.5K ohms, this product reads 2meg ohms. So I was unable to pre-calibrate the TPS based on resistance.So I was bit concerned. However the controller reads voltage, so I felt it may still work.The installation was easy, but I don't have a TPS meter to calibrate for idle.So it took a few adjustments to achieve both a good idle and running condition.I have driven my Polaris at least 5 miles each evening (varying speeds) with no serious issues arising.There's a minor backfire during deacceleration, but that may indicate I still need to make a minor adjustment.I recommend this product for a 2007 Polaris Ranger 700 XP.
J Dawg
Reviewed in Canada on June 5, 2023
The TPS sent to me was the correct unit however it was faulty. I am confident that it was faulty as I tested it along side a working TPS. The return policy was good and easy enough to use. Quality control for these sensors seems to pretty low from the wholesaler, I would suggest that the vendor stops carrying this product so as not to affect their overall ratings as a vendor.
Ian
Reviewed in Canada on November 30, 2023
Even after polaris calibration procedure. Watching the signal on an oscilloscope it's quite uneven and the top end resistance is greater then the original. So it'll only read a max of 75 percent throttle
Customer
Reviewed in Canada on August 13, 2022
I tried installing this on my 2013 Polaris Scrambler 850 xp. The add stated the right part number for the TPS but the TPS itself is wrong!! Had buy one from Polaris. Don't waste your time buying this product from this company!
Couch rider
Reviewed in the United States on January 14, 2022
Couldn’t get it to do right ,may have been me . Try one for the price!!!
Alexandre F.
Reviewed in Canada on March 7, 2021
Polaris 800 efi 2005 et ce produit ne fonctionne pas !
Berry George
Reviewed in the United States on December 12, 2021
Arrived on time and it worked great.
dracette
Reviewed in Canada on September 3, 2020
Could not make it running right so I re- installed the old one back on
Anthony
Reviewed in the United States on March 14, 2020
Exactly what I needed took some time to get adjusted Wright. with a manual and a multimeter. motor runs excellent what an improvement .
Daniel Altman
Reviewed in the United States on January 10, 2020
Used this on my 2007 Polaris Ranger XP 700. I was nervous about some of the negative reviews and the adjusting hole needed drilling out. I install this TPS with in modifications and it’s currently working great. I will return to give a one year review.
saint1000
Reviewed in the United States on June 15, 2019
the sensor did not have enough adjustment to bring base value voltage in to spec. i had to roto zip the mounting hole to get with in spec. After 1 day of riding tps would not keep its idle voltage. I'd set to.715 volts and after I run down the road voltage would drop to. 689. Not worth the money saved
todd morton
Reviewed in the United States on November 3, 2019
Works great. I had no problem installing just make a mark on the old one to get the bolt in the right spot.
Recommended Products