Your cart is empty.
Your cart is empty.The Edelbrock Air Cleaner Spacer allows additional clearance between the carburetor and air cleaner for custom linkage, return springs, fuel lines and electric chokes. The air cleaner spacer is designed to fit between the carburetor neck flange and the air filter assembly. The air cleaner spacer is made from durable, high impact plastic with a black finish. It fits all carburetors with a 5-1/8' inch diameter neck.
Doc
Reviewed in the United States on October 13, 2024
No complaints
Brian
Reviewed in Canada on June 5, 2023
Item exactly as described. It fit my carburetor and breather.
Richard
Reviewed in the United States on October 18, 2023
Just the right spacing on my carb and air filter
philip Stone
Reviewed in Canada on September 15, 2022
ok
Cali
Reviewed in Canada on August 26, 2021
exactly as described
Mark
Reviewed in the United States on March 4, 2021
I don't like that it's plastic but I didn't want to pay too much. I just needed a temporary solution until I get my new carberator and intake and this works perfectly.
Agustín Rom
Reviewed in Mexico on May 11, 2020
material muy delgado
Audi99
Reviewed in Canada on November 19, 2020
The product quality is excellent, overall depth was more than I expected but is workable.
P. Guillotte
Reviewed in the United States on October 29, 2019
This is an AIR CLEANER SPACER, that is all. And it fits like a fine glove to my '79 Vette's Edelbrock carburetor and docks with my Air Cleaner as if it were a space capsule to the Mother Ship. There are no vacuum leaks and you can not see it with the Air Cleaner on the engine. Yes this is plastic. So what. I ordered an aluminium one that did NOT fit at all and had to return it. Edelbrock ROCKS!!!. My entire engine has EDELBROCK performance inside and out. You can not go wrong with them.
M
Reviewed in the United States on February 23, 2018
The diameter is slightly small for the Motorcraft 2100/2150. Its not close enough to use on my specific 5-1/8” base carb due to interfence with the choke linkage and it doesn't sit 100% flush to the recessed rim. So close though. On the topside rim it adapts perfectly and as expected to the Edelbrock10023 cleaner. Good, well made part if it fits your application.
Scott Elliott
Reviewed in the United States on January 19, 2018
It’s a great simple riser. It fit my brand new Edelbrock 1406 perfectly and lifted my air filter off my Ford 300 to make room for my throttle cable.
BeeVee
Reviewed in the United States on March 19, 2017
Fit perfectly. These distort over time from heat and getting a new one now and then keeps a good seal at the air cleaner base. I use a small bit of silicone adhesive to mount it to the bottom of the air cleaner.
c in ok
Reviewed in the United States on December 3, 2017
needed this to space up factory air cleaner, did fit and worked great, is plastic, concerned it may break but so far so good
Recommended Products
$26.09
$ 12 .99 $12.99
$23.24
$ 10 .99 $10.99
$55.99
$ 26 .99 $26.99
$35.13
$ 16 .99 $16.99
$77.49
$ 36 .99 $36.99