Your cart is empty.
Your cart is empty.
Key Features
- Plugs directly into the receiver using standard servo connectors
- Connect and control multiple mechanisms with a single radio channel
- One-by-one and programmed delay modes
- Electronic and manual release mechanisms
- Ready to use and easy to install
Overview
The E-flite servoless payload release enables you to drop a single payload while in flight, or enables you to use multiple devices to drop multiple payloads using only one channel on your receiver. It can also be used as a tow release for sailplanes.
Braydon Elgar
Reviewed in the United States on November 29, 2024
These things work great. They work everytime. They are a good small size to fit on most rc planes
Fighterpilot
Reviewed in the United States on October 14, 2023
Product was as advertised and works very well. I installed it on a EPO foam model jet. All I had to do was plug it into a spare receiver channel, dedicate a switch to the operation and it was bombs away.
Gene
Reviewed in the United States on November 9, 2021
seller: please discard this batch that you are fulfilling Amazon orders from, it seems defective.Here is what I did: I connected them to 6V worth of AA batteries (four batteries) and a servo tester (or an RC receiver too, with the same result).Instead of a proper release there was just a clicking sound, in both cases.To figure out where the problem is, I took the first of the defective devices apart -- the servo motor itself seems fine, but the sensor in the controller seems to be defective (mostly doesn't even make the motor return back after I manually rotate it out of the neutral point).
Larry S.
Reviewed in the United States on September 6, 2018
Easy to hook up and it worked the first try. Thinking about buying a few more of these.
Esteban
Reviewed in the United States on February 14, 2018
Needed to add a payload release to my drone, hooked this up to a receiver and power and had no issues. I used this many times to drop teeshirts in the crowd with no issues. 3d printed a bracket to hold the release, receiver, and battery and you are good to go.
Customer
Reviewed in Canada on December 23, 2018
Does exactly what it is supposed to
Ardalan
Reviewed in Canada on January 20, 2018
Works like a charm every time. Holds a lot of weight
PNS
Reviewed in the United States on May 30, 2016
Seems like good product. In our case we needed additional technical data that was not easy to find. (How to trigger device from Arduino rather than from RF receiver.) Provider responded to email with manufacturer's phone number but we ended up figuring out solution using internet forums. (Use servo writeMicroseconds() function.)
Brad Jensen
Reviewed in the United States on February 12, 2016
I use three or four of these connected to a separate receiver to drop things from my DJI Phantom 3 Pro.Mostly waterbombs. Biodegradable.Not on people of course, just for fun.
Red Route One
Reviewed in the United States on December 14, 2014
Works as it should, it fit nicely in the model that I purchased it for (model had a premolded location for it). No issues and no problems. It's a nice little device for what it is.
Recommended Products
