Your cart is empty.
Your cart is empty.Falcon man
Reviewed in the United States on June 8, 2024
They fit the Milwaukee buffer that I got them for
digi
Reviewed in the United States on September 2, 2023
As others have stated, the fitment of this thing is terrible, and it will barely hold on to bit shanks and when it does they are so far out of center it is impossible to use. This actually comes down to a single flawed part which is the collet nut. It is not fully machined out and the collet hits the unmachined are first preventing the nut from going on completely and causing it to push the collet off center because it is not sitting on the beveled edge. I was going to return the entire thing for a replacement, but then I saw others have had the same issue as me so I assume I'll just get another nut that does not work correctly. Since the other parts work I will just find a new collet nut. I have tested with the collet nut off my Milwaukee die grinder and it works perfectly. In my attached photos, you can see the included nut which has the writing on it and how it leaves the collet recessed and off center, compared to the Milwaukee nut which is the shiny black with no writing in the last photo.
Bill
Reviewed in the United States on July 18, 2023
The media could not be loaded.
Dennis
Reviewed in the United States on May 16, 2023
Just did exactly what I needed added a quarter inch collet to my Milwaukee M12 buffer
roger suders
Reviewed in the United States on August 28, 2022
As many other reviews stated that it is not machined very well. I found this to be true. I ordered another set of ER11 nuts and just like that I'm in business. But to be completely honest I have found another adapter that works better than this for my Milwaukee M12 Polisher Sander.If you are looking to make the most out of your Milwaukee M12 Polisher Sander don't look anywhere else just get this SUPROJDM 5/16-24 Threaded Adapter for Milwaukee M12 Polisher Sander
Prime member
Reviewed in the United States on October 26, 2022
Seller description is accurate it does fit Milwaukee M12 Polishers odd thread size. However, not quite what I was hoping for.1. Both Collets 1/4 & 1/8 are very tight fit into coupler and when screwed down/tighten it doesn't seat all the way. Maybe only tightens down maybe a few turns at best? The drill attachment doesn't feel secure and wants to spin on the collet. So you'll need to use a wrench on both fittings to really snug the drill attachment. This makes it some what cumbersome to take off and on?2. When collet is tighten down the attachment is not exactly centered - might not be an issue for some attachments but if needing to do a little more accurate grinding the attachment will not spin perfectly.FYI Not the fault of the design or description but was also "hoping" to attach "hex bit" drivers to this collet. Note this 1/4" collet is too small to fit these. Only round 1/4' bits or attachments will work.
Reviewer
Reviewed in the United States on April 16, 2022
I've tried two of these and they have both had a lot of runout, making using a roloc sanding or conditioning disc basically a non starter. I found it was acceptable only for super slow speed buffing and polishing with a super soft foam pad. The collets are decent enough quality, the collet nutvis also fine, the adapter itself just suffers from really poor QC and setup during second operation on the turning center to cut the mounting threads coaxial to the centerline axis of rotation.
Dickw
Reviewed in the United States on November 3, 2021
Arrive ok and is well made, two collets and works well
Recommended Products
$15.36
$ 7 .99 $7.99
$58.00
$ 26 .99 $26.99