Your cart is empty.
Your cart is empty. Programming via Remote control :
Step 1: enter programming
Power on the remote control → pull the remote control lever to the highest position → power on the ESC, wait for 2 seconds, and then emit two beep-beep-, the maximum throttle setting is completed → continue to protect.
Hold the remote control stick in the high state, wait for 2 seconds, and emit a melody tone of "♪ 123 ♪ 1 2 3", indicating that the remote control programming mode has been entered.
Step 2: Choose a programming project
After entering the programming mode, keep the remote lever pulled up to enter the project selection. There are 7 items in total, corresponding to 7 different tones, which are circularly selected in the following order.
After the beep of a certain option, pull the throttle stick to the lowest within 2 seconds to enter the option.
1. "Beep-" (1 short tone), brake selection
2. "Beep- beep-" (2 short tones), timing setting
3. "Beep- beep- beep-" (3 short tones), start velocity
4. "Beep- beep- beep- beep-" (4 short tones), curve setting
5. "Beep-----" (1 long tone), control frequency
6. "Beep----- beep-" (1 long tone and 1 short tone), low voltage protection setting
7. "Beep----- beep- beep-" (1 long tone and 2 short tone), low-voltage cut-off method
8. "Beep----- beep- beep- beep-" (1 long tone and 3 short tone), direction setting
Step 3: Select item value
After selecting an item, keep the remote control stick in the low state, and then enter the cycle selection of the parameters of the item. Each prompt tone (four short tones followed by a long tone, So on and so forth). After a certain prompt tone, within 2 seconds, pull the remote control stick to the highest position, and a melody tone of "♪321 ♪3 2 1" will be emitted, which means to save the parameter. maintain
The extended state of the remote control stick remains unchanged, then continue to the next project according to the method at the beginning.
Rick Rucker
Reviewed in the United States on March 22, 2024
I have bought these before but needed more of them. They got here early and in great condition.
Jason M.
Reviewed in the United States on November 22, 2024
All 4 ESCs were previously used and 3 were burnt up. Ordered them and put away for a future project. Recently opened them to discover this.
David Just
Reviewed in the United States on December 13, 2022
the power wire is too short, and they are bigger than I expected them to be. I just replaced all the wires with my own.I've only tried one so far, but it works.
Customer
Reviewed in the United States on March 28, 2021
First one to hook up would tone but would not do anything else but twitch. Tried another one, and it’s working for now...
Recommended Products
$129.99
$ 54 .99 $54.99