Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
Marcos Del Cid
Reviewed in Mexico on September 9, 2024
Se ajusta perfectamente a mi hilux 2008, motor 2.7, se eliminó la fuga. Muy buena calidad.
Robert Giordano
Reviewed in the United States on May 27, 2024
This was perfect for my 2005 Tacoma. It was easy install and I am very happy with my purchase. I installed it in an hour and a half.
Mike
Reviewed in the United States on May 1, 2024
Perfect fit for 2007 Toyota Tacoma 4 cylinder engine. No leaks. Make sure to use RTV at the two small matting surfaces. Install valve cover hand tight, let RTV dry for approximately 30min, then torque to specification.
Customer
Reviewed in the United States on October 16, 2024
Worked great and sealed leaks. What more could you want
Some Way
Reviewed in the United States on August 30, 2023
Put on a 2.7 Tacoma engine and the original 13 year old silicone gasket was brittle when removing.
Ricky
Reviewed in the United States on August 19, 2023
Seems to be a good quality part that was packed and shipped very well. Would recommend.
Steven VanRensselaer III
Reviewed in the United States on August 18, 2023
2005 Toyota Tacoma 4 cyl. I had a valve cover gasket leak at the right rear corner. This wouldn't be an issue normally but it was going right on the exhaust manifold and causing oil fumes to enter the cab.The old gasket was very hard and brittle. The new one went on nicely. No leaks.
Chris Ellsworth
Reviewed in the United States on February 6, 2021
When I set this into the cover I expected it to fall out but it didn’t. It stayed in place on its own until I could get the cover in place. Very important point because the cover is hard to set in place under a wire harness.
PAINZGOAT
Reviewed in the United States on June 9, 2019
Put it under your floor mat for a few hrs... It is shipped really wadded up......
Recommended Products
