Your cart is empty.
Your cart is empty.Flowmaster 817519 Xtra Cab and Double Cab Cat-Back Exhaust System for Toyota Tacoma 3.4L V6 Engine
akakaroach19
Reviewed in the United States on July 4, 2021
2001 prerunner dbl cab with 2” lift. Instructions were somewhat helpful. Installed with tires on the ground on the garage floor. No lift or jack stands were used. Installation time 2 hours. Whole system fit very well.2 sawzall cuts first were helpful. 1) Cutting mid-pipe just after O2 sensor flange and 2) after muffler before unbolting form flange.Flange bolts needed to be cut off at the mid pipe flange side to avoid damaging the catalytic converter. Cutting off the O2 cable support on the chassis to give you some slack which will help allow you to have better access to remove the O2 sensor nuts. Original hardware for O2 was totally corroded. I wedged/hammered on a deep socket and used an air impact gun to remove.Must purchase separately O2 sensor gasket and flange gasket (catalytic to mid pipe)Exhaust sound is quite a bit louder than stock but not to loud.
Tater
Reviewed in the United States on August 1, 2018
I guess it would have been awesome if I had a California emissions Tacoma. After having to cut and splice to make it longer and$60.00 out of my pocket I made it work. Customer service is terrible.
Jim
Reviewed in the United States on January 25, 2018
It fit really good and sounds great
Readasaurus Rex
Reviewed in the United States on April 7, 2015
Awesome Flowmaster sound and connected (relatively) painlessly to my 02 Tacoma. You do have to add an extra hanger as it will not fit in the rear stock hangers and the bolt that came with the kit was too large to fit through my frame. I didn't go five stars on this because it DOES NOT COME WITH GASKETS or mounting hardware, so you will have to buy your own. Not a big deal since the gaskets came to $4 (O2 sensor and flange), but just something to be aware of. If you can't recycle your existing hex nuts from your O2 sensor, I used 8mm lock nuts and they worked perfectly.
Timothy
Reviewed in the United States on November 26, 2014
Easy install, sounds great! Don't forget to go buy a new O2 sensor gasket and a new gasket for intermediate pipe to catalytic converter connection. You'll need them as I found out...you cannot possibly reuse the old ones as flowmaster states. Wish they included them as this is why they didn't get five stars from me.
Nate
Reviewed in the United States on August 4, 2013
Doesn't sound as good as I thought. I couldn't get the factory claps to fit. Gas mileage didn't go up much as originally advertised. Awkward instructions, but you could still figure it out. Decent investment I suppose
don w smitley jr
Reviewed in the United States on August 3, 2012
This exhaust was shipped to me with the wrong clamp which is not big enough and that left it leaking the welding they did splattered all over the threads for the 02 sensor i had to file all that out to be able to thread the nuts onto the studs and one of the hanger mounts hits the frame i had to trim that with a die grinder also its loud!
Recommended Products
$674.99
$ 99 .00 $99.00
$1,089.23
$ 99 .00 $99.00
$564.99
$ 99 .00 $99.00