Your cart is empty.
Your cart is empty.Customer
Reviewed in Canada on March 11, 2025
DONT BUY THESE INJECTORS FOR FORD EDGE OR ANY OTHER CAR!!!!DIDN'T FIX MY ISSUEI THINK ONE OR TWO INJECTORS ARE NOT WORKING!!!GO BUY OEM ONES!!!!
Alex Kilpatrick
Reviewed in Canada on April 1, 2025
I had 1 injector reading PO201 & PO301 on my diagnostic reader. One faulty injector.I decided to order this set of 6 to avoid having to chase another one in the near future. Having installed 6 injectors, the car hesitates when accelerating, stumbles under hard excelleration and bucks when decelerating. New POs show PO 2196 & 2198 indicating as below.The P2196 code indicates an issue with the oxygen sensor signal, specifically that it's ...
Lucinda
Reviewed in the United States on September 7, 2024
Wrong o-ring motor side not big enough also for the clip the injector on the wrong angle
Lissett campos
Reviewed in the United States on August 25, 2024
I bought them an it said it fit my vehicle. They fit but when trying to clip them on the slit was on the wrong side.
Russ L.
Reviewed in Canada on August 12, 2024
The grooves that the clip is supposed to fit in are cut 180 degrees out of wack. Just no way to make them work. I had to return them
Keaton Brookman
Reviewed in the United States on July 30, 2024
Injectors work but keeps making my car throw code saying 02 sensor bank stuck rich. The inside holes of Injectors are a bit smaller and has a screen in them compared to the ones I took out with more open hole for fuel. Maybe that is the problem but not for sure. So far my car is still running though.
Denis Leblanc
Reviewed in Canada on July 26, 2024
Les injecteur presque identique trou d'entré de l'essence pas le même diamètre et l'intérieur n est pas identique les trou d'injection pas le même diamètre le moteur fonctionne mal ne peux roulé RPM très bas et code OBD2 des oxygènes sensor allumé
Frank M. Woods
Reviewed in the United States on August 27, 2023
I installed the units in my 2010 ford edge.
ME
Reviewed in the United States on July 22, 2023
I put these injectors in my 2007 Ford Edge SEL 3.5L and they work great. They were shipped out fast and I had no problems installing them. ⭐⭐⭐⭐⭐
Sergio O.
Reviewed in the United States on May 6, 2023
I bought it for a 2008 MAZDA CX9. I had to buy an o-ring kit to replace the ones on the bottom, (the ones on the bottom are smaller). The slot to put the fastening locks comes in a different position.The worst thing was that it gave the COD P2196 and P2198 Stuck Rich, After changing some parts that Autozone told me, I ended up in a mechanical workshop to have a diagnosis and find the problem (much more money and time). probably fit for Ford Edge, NOT MAZDA CX9
Hussain H.
Reviewed in the United States on March 21, 2023
Very niceAnd working goodFit perfectly to my ford edge 2008
Big D’s Music
Reviewed in the United States on February 22, 2023
Liked that the injectors came in a pack of 6. I have a 2008 Ford Edge 6 cyl and these fit perfectly. Haven’t had an issue yet.
Recommended Products