Your cart is empty.
Your cart is empty.Gator Frameworks Series desktop mounted microphone boom stands are the clutter-reducing stand solutions perfectly suited for broadcasters, podcasters, content creators, radio hosts, and on-air personalities. Each boom arm includes both a clamping and mounting base attachment mechanism to best accommodate your particular setup needs and swivels a full 360-degrees. All stands are engineered specifically to reduce noise brought about from moving parts and can be adjusted to hit desired angles, providing you with quiet and easily customizable mic placement options. Concerned it won’t hold up your large-diaphragm mics? Ditch the worry, for all models are designed to bear the weight of the heaviest mics in your collection, making the desktop mic boom stand series by Gator Frameworks a group of rugged stands you can truly count on!
Mar🐋
Reviewed in Spain on January 11, 2025
The media could not be loaded.
Kevin Rocha
Reviewed in Mexico on July 21, 2024
Cumple con lo que dice
Hamad Khalid
Reviewed in the United Arab Emirates on June 25, 2024
Dont think, just buy it, its worth it!
sajid ali khan
Reviewed in India on June 15, 2023
The arm is amazingly well built and looks awesome tensions hold my shure sm7b effortlessly just buy it on sale 11900Or you can go for rode Psa1+ that is also one beast of a boom arm
Erik
Reviewed in the United States on August 12, 2022
I decided to upgrade my recording setup this month. As the investment kept rising I found it easy to justify a boom arm upgrade...I had one of the cheaper boom arms you could buy on Amazon, it came in at a little more than 1/3 the price of this one. And while it did the job, it felt and looked cheap and was extremely stiff. It was also a bit short.This Gator Frameworks 3000 remedies all of that. It looks great, operates almost effortlessly and smoothly. And if you are upgrading to a mic that needs an XLR cable like I did, it includes a nice and long XLR cable, saving you about $20. It's a great value even without the cable, this makes it a no-brainer.The cable runs through the inside of the boom arm. This makes for a nice clean look. But, as far as I can tell, to change out the cable you'd have to run a naked cable through a small hole in the bottom, disassemble the stand to run the cable through (not too difficult) and then solder/crimp/however-you-attach-an-XLR-connector. I show a pic of the only spot I found that would require the connector to be attached after assembling. I suppose you could Dremel the top of that hole off and you'd be able to run your cable with the connectors attached. Maybe. (Hole close up shown in pic.)All this cable talk leads me to the one little gripe I have about this unit. The whole unit is black. So why, oh why, did we have to use a silver XLR connector on this cable? The reason it bothers me is that when on video if I have the mic in real close, that silver connector jumps out and draws attention. Without it the whole unit would just blend in and be much less noticeable. Tiny gripe, I know. I'll be painting the outside of the connector and my trauma will soon be forgotten.*** Note about the desk mount: I'm using the desk mount from my old boom arm, the pins are the same size. The mounts that come with this unit are awesome though! Very robust. It comes with one that can be screwed to the desk top — I might end up using that one. The other one is a really solid desk clamp, it just won't fit where I have my unit located, in a small crack between the desk and a desk extension I have my phone on.
Edgar da Silva Leite Filho
Reviewed in Brazil on August 10, 2022
A entrega foi rápida e o material é muito bom. Recomendo!
Patrick
Reviewed in the United States on June 13, 2021
Honestly, before I purchased this arm, I couldn’t justify spending over 100 dollars on a microphone arm. It just seemed ridiculous quite frankly and I figured this was something I could get by on by using cheaper arms. But after going through a couple of cheap setups that were simply either poorly designed or would lose strength to hold up the microphone and would collapse after short use. I figured I might as well invest in a “good arm”. So naturally I looked up what Joe Rogan uses in the new studio and this is what came up. As soon as I took it out of the package, I could tell it was built different from the rest and was far sturdier and heavier. The installation was very easy as well. As soon as I started to adjust it with my microphone, I realized I should have just bought this right out of the gate. I probably spent just as much money on the cheaper ones if I added them all up. No matter what position I wanted the mic at, it held up perfectly, even at positions where the arm was fully extended out(where my other arms usually collapsed). I even left it in a somewhat “taxing” position for a week and it still held the mic right where I left it last. To add to it, it has a built in XLR cable. Call me a newbie but I always wondered how the major podcasts didn’t have cables wrapping around the podcast arms like I always had... that’s because the cable is built in(of course). So in addition to its sturdiness, it makes your setup look more clean with the built in cable and saves you from having to buy an extra cable. All in all, I love it. If you are in the same boat as I was, this is money well spent. Great product!
Chris
Reviewed in the United States on February 17, 2021
This boom arm is amazing. I wanted the rode psa 1 to match my rode pod mic and rode interface but it was not available. I'm not disappointed at all!Easy to move into position. Comes fully assembled and ready to clamp onto your desk, or they have a very nice desktop mount I opted to use instead. It came with some very nice coarse thread screws to securely attach it to a desk.The xlr cable included seems very good quality, metal end connectors. The knobs can be secured down firmly to keep it in one place, or left semi tight so you can move it around more easily if you actively move your mic around while using it.The sound isolation from my desk noise is very good! Coming from a traditional desktop mic stand, I used to be able to hear every click of the mouse and keyboard stroke. Not anymore!My only complaint with the boom arm is the final adjustment point that the mic attaches to. I wish it adjust the opposite direction it currently does. It looks possible to flip it around but I'm not sure if i want to try because it functions well enough as is.Overall I love how safe my microphone feels when on the stand and would absolutely recommend this to anyone needing a boom arm.
Recommended Products
