Your cart is empty.
Your cart is empty.Protect your drive from damage with SkegShield "The Ultimate in Skeg Protection". Marine grade stainless steel with a reinforced lower edge for protection from impact and an EXCLUSIVE drain hole to prevent water retention. Made in Polished Mirror Finish. Can be installed on a new skeg or one with as little as 2'' left in about 10 minutes. 3 Year Warranty for Original Purchaser.
JJ
Reviewed in the United States on September 13, 2021
I hit a sand bar and a buried rock took out a chunk out of my skew. To get it welded was going to cost $450. Ordered this. It fit on so tight. A rubber hammer was needed to lightly get it on perfect! Then, drill 2 holes and tightened with the enclosed stainless steel screws. The screws are designed to shear off if in the future you hit something hard. So I’m now asking myself why not install even if you don’t need yet.
Chappy
Reviewed in the United States on November 20, 2020
Good easy installation fit nice. Looks like a nicely well-built product. Works just fine
Ahmad Mims
Reviewed in the United States on April 10, 2020
Makes the boat stand out. A had a few scratches on my Skeg. Sanded them down and used this plate to cover them up. Works great.
Gary Shaughnessy
Reviewed in Canada on August 15, 2018
Excellent, recommend for all boaters and great finished look too.
Lavswife
Reviewed in the United States on July 29, 2018
For my bravo 3 like a champ. Installed in under 5 minutes. Looks better than the regular skeg. Covered my broken self and I’m on the water like it never happened.
SDS
Reviewed in the United States on January 27, 2018
I like the look of this product and it was easy to install. The fit was good, but not perfect. That is the only reason why I gave 4 instead of 5 starts.
McGee
Reviewed in Canada on July 19, 2017
Fit perfect and looks great
Birgs
Reviewed in Canada on March 25, 2017
When I pulled my boat out of the water last year I found that one of my skegs was damaged. When I came across these, I thought, why not try this as opposed to removing outdrive and having my skeg repaired. My boat is currently laid up for the winter so at this time I cannot comment on the quality or ease of installation.
Sean Duquette
Reviewed in the United States on November 7, 2017
Screws were too short. I had to improvise a bit with a trip to the hardware store.
A cust
Reviewed in the United States on October 10, 2017
I purchased this back in 2014. Install was very easy. Attractive shield. I have never struck anything in the water, but I think the previous owner did because there was a small chunk taken out of the skeg and this item restored the look and function of my Bravo 3 drive. However, this year I was very unfortunate and struck a submerged shoal. We were travelling slowly, and I had just looked down to get some beef jerky from my son and it happened. I thought it was going to be bad the way the boat reacted (30 foot). Immediately I went into the mode of inspecting and checking for leaks, and even dived off the boat to inspect hull and drive. All I could be certain of, was the drive had struck. The props looked fine, and rotated nicely. Running the boat home to the marina I was testing for vibrations, and steering, and everything felt fine. The drive performed the rest of the season, although I only went out one more time on it. Now, boat is out of water for the year, and I can really inspect for damages. No hull damage, hull missed the shoal! YAY! But, the drive skeg shield took the brunt. It performed just as it should. One mounting bolt was sheared off, and the shield was bent. But, that looks to be the worst. Drive will be pulled however, serviced and repaired as necessary! I will buy a replacement shield!
Customer
Reviewed in Canada on May 9, 2016
fits good
OnlineShopperYYC
Reviewed in Canada on September 21, 2015
Easy to install and fits relatively well. Mounted on a 2006 Bravo 3 2.0 leg with 24P props. There was a gap between the vertical (closest to props) skeg and the guard that looks like it is too big... just an observation.This is my second purchase - ensure you use locktite on the bolts. They have a habit of coming off. When mine did the guard slid into the props and well, enough said.
Kasie Smitherman
Reviewed in the United States on November 3, 2014
PRODUCT DOES NOT FIT ALPHA 1 GEN 2 GREAT LOOKING SKEG JUST MAKE SURE IT FITS.
Recommended Products
$32.99
$ 15 .99 $15.99