Your cart is empty.
Your cart is empty.
Product name:Fuser Upper Heat Roller + Pressure Roller + Cleaner Pinch Roller S set
wm123
Reviewed in the United States on May 26, 2024
It isn't the easiest to put in but there are videos online and it is a LOT cheaper than buying a fuser. Fixed the wrinkled paper problem.
Jose R. Viera
Reviewed in the United States on February 25, 2024
Vino dañado
Windonface
Reviewed in the United States on January 20, 2024
Get instructions online before attempting. Great value otherwise.
No Name
Reviewed in the United States on April 21, 2024
Use it to repair a Bother color printer. The old fuser roller was causing a paper jam because the red silicone roller was going bad. Much cheaper than purchases the entire fuser assembly but you have to be able to take things a part and put back together without instructions. Careful do not break the fuser lamp and be careful to routing the fuser lamp wires when putting fuser assembly back
Bill
Reviewed in the United States on April 19, 2024
These parts appear to be high quality replacements for the fuser rollers and so far they are working well. However, while removing the fuser assembly isn't that difficult a task, taking apart the fuser to replace the rollers is. Next time I'll probably save myself the aggravation and buy a whole replacement fuser unit. These rollers cost maybe 20% of the complete fuser unit, so that savings was hard to pass up... but be warned, it's a difficult job.
S W
Reviewed in the United States on May 8, 2023
Exactly as described. Perfect fit & easy to install. Works great.
gracer718
Reviewed in the United States on December 26, 2022
This is exactly what needs to be replaced in the fuser for this specific printer. HOWEVER, there is a glass tube running through the center of the black roller that will break if you do not disassemble it correctly. Ask me how I know. I had to source that part on eBay.It’s not hard to replace the rollers and saves a ton of expense, but it’s a tedious process. I recommend taking photos along the way so you can reassemble correctly. Highly recommend this product to extend the life of your printer. Saved me $200.
Sarah K.
Reviewed in the United States on December 24, 2022
The parts worked great. The install took about 2 hours. I had no idea what I was doing but watched a couple YouTube videos of models that were different than mine. Most of the main idea was the same.1. Free the fuser.2. take it apart. Remove springs.3. Unhook the power lines from the heating element. The yellow cord was hard to find had to remove a rear cover. There is a power hookup on each side of the heating element inside the black roller. Once unhooked remove side screws and pull out black roller.4. Transfer parts to new black roller. End bearings and heating element.5. Put it back together.Replace small white wheels on paper feed thingy.Done.Would recommend. Parts fit great and test prints are nice problems solved. For now.
Recommended Products
$159.99
$ 77 .99 $77.99