Your cart is empty.
Your cart is empty.HHIP Pro-Series T-slot nut is made from case hardened 1018 steel with black oxide finish. It is clamping components and machine tool accessory. It measures 44mm length by 44mm width by 36mm height.
Joel Prevette
Reviewed in the United States on June 11, 2019
The base dimensions are shown to be 21mm wide with a shoulder height of 7mm. This would have worked for me but they are actually 17.5mm x 6.5mm. The overall height is really 14mm as advertised so that leaves 7.5mm at the top. I will have to grind off at least half a millimeter so that it doesn't protrude above my drill press table top. The slot in my drill press table is 17mm wide so the nut is barely wide enough that it doesn't pull through the slot. I also had to run a 10mm tap through each one so that I could thread the bolt through. The threads at the exit end of the hole were too shallow for the bolt to pass through.
Recommended Products
