Your cart is empty.
Your cart is empty.Ground-up design, packed with technologies for Rock Crawlers What's in the box 1x FOC motor w/ built-in ESC Factory-installed XT60 plug 1x Decal and Manual 1x Heatsink kit, double-sided tape, and zip ties. Bottomline The integrated design of the ESC and the motor greatly reduces the overall volume and weight and makes the layout and wiring of the car frame simpler and more convenient. In the FOC driving mode, low-speed torque is strong. Smooth running at extremely low speed, which is far superior to the common sensored brushless power system, even better than the brushed power. Thanks to the sine wave driving mode, the whole system has high efficiency, small heat, and effectively extends the endurance time; and the motor runs more quietly and soft. The protection grade of the whole system is IP67, with excellent waterproof and dustproof performance. Under various weather conditions, the whole system can easily deal with the complex road surface containing silt, ice and snow, and water. Intelligent torque output and speed closed-loop control, fully experience the cruise control and steep slope slow descent function of 1:1 vehicle, making the control handy. Active drag brake force adjustment, providing unprecedented parking capacity on a slope. With a strong built-in switch mode BEC, the continuous current is up to 6A, and support switch between 6V and 7.4v, easy to drive various powerful steering servos and high-voltage steering servo. Multiple protection functions: battery low voltage protection, overheat protection, throttle lost protection, lock-up protection. Supports Hobbywing LED program box to set ESC parameters and has an independent parameter setting interface, which is integrated with an electronic switch, making setting parameters more convenient. Quicrun Fusion Specification 1/10 FOC brushless 540 'spec' motor w/ a built-in-ESC (Patented design) Motor Volume:550 Product Brochure (pdf) Spec Comparison (pdf)
Mikey w.
Reviewed in the United Kingdom on September 11, 2024
The media could not be loaded.
Michael easlick
Reviewed in the United States on March 18, 2024
Best replacement motor for crawlersGives you that extra power when you need it and great response time and slow speed for climbing
Richard Hemingway
Reviewed in the United States on March 1, 2024
So I got one and something wasn't quite right about it, it wouldn't program, and wouldn't turn after quarter throttle. but the second one I got is so friggin impressive. it's in my trx4 high trail, and the low end is amazing, and it also has tons of speed, it'll haul a wheelie, I turned down the max throttle where it's in a crawler, but this 2 in 1 came highly recommend and it's clear why. Hobby Wing didn't get back to me on the first one, so that part sux. I had heard good things about there customer service. So I don't know. I never did contact the seller, due to it being such a long time before I actually installed it.
Fred Vacca
Reviewed in the United States on January 24, 2024
My first time using brushless motors. Super easy install. Love the 2 in 1 feature!!
Matthew Stobert
Reviewed in the United States on July 9, 2023
The low speed control is outstanding. The programming cards are cheaper and have mor features. The spektrum isn’t bad. It’s just that these are better.
Brian Morrison
Reviewed in the United States on May 4, 2023
Smooth, quiet, strong and the drag brake is perfect out of the box. No programming needed. I immediately ordered one for my Vanquish Ultra.I have ran 4 battery packs through it and broke in a set of tires. I have found my motor esc combo 👏
Clay Roberts
Reviewed in the United States on April 8, 2023
Put one my 4WS Capra. Amazing difference. The slow crawl is crazy, but it has that wheel speed when you need it. All in all it was what my Capra needed, but here are a few things you should know if you're doing this.1.Only the cheap program card works with it for some reason. You'll need to reverse the motor. Don't do it on the controller, fwd and rev are different.2. Capra has esc and receiver as one, so plan on changing the receiver/controller as well. Or find a receiver that works with the original controller. I went with FS-G7P.3. You'll need to shave some plastic(not much) to make it fit. Or change skid plate(I went with a new flat skid)
Travis D.
Reviewed in the United States on April 7, 2023
This motor rocks!! Make sure you get the program card with it though, as it doesn't come with it.... Super surprised at how powerful this motor is, like you can barely hold back the crawler by the bumper. Programming is easy as well, just YouTube it if you have any questions. Highly recommend this for sure for anyone thinking about upgrading their crawler motor. Tons of torque and speed too, super slow crawl is amazing!
Victor Vincent Swann
Reviewed in the United States on April 4, 2023
Spent 10X stock. The motor requires mods as you don’t use the stock speed , that’s minor soldering and plug changes, and I wired the light kit to the battery. The motor is faster, has more power than stock- the speed control has a better crawl. All in all? Let’s say….. at x10 cost, the performance is say…30% or x0.3 better….. so. If you’re just having fun it’s a little expensive. If you really want to crawl and what not then yes. I overdrive the front diff, replaced the front servo as well as weighted the wheels.
Recommended Products
$172.64
$ 76 .99 $76.99
$17.50
$ 8 .99 $8.99