Your cart is empty.
Your cart is empty.From the manufacturer
Hornady Lock-N-Load Accessories
There are many reasons to handload your own ammunition. It’s fun, economical, and rewarding and you can attain maximum accuracy if you have the right tools. Hornady provides everything you’ll need— from presses and dies to case care and measuring equipment, we have it all. Start here and get in the zone!
Cam Lock Bullet Puller Collet
Works with the Cam Lock Bullet Puller
These interchangeable collets are used with the Hornady Cam-Lock bullet puller. There are thirteen different collets that will pull most any bullet, from 17caliber through 458 caliber, except a flush seated wad cutter.
About Us
'Ten bullets through one hole' was the philosophy of Joyce Hornady, the company's founder.
Founded in 1949, Hornady Manufacturing has become a world-leading innovator of bullet, ammunition, reloading tool and accessory design and manufacturing. At Hornady, ammunition is more than their livelihood. It's a major part of their daily life.
Hornady acquired SnapSafe in 2015 to complement and expand their offerings in the security products market segment.
Leo
Reviewed in the United States on March 6, 2025
Works fine and the bullets can be reused.
Hog Killer
Reviewed in the United States on March 23, 2025
Best extraction out of all
david birney
Reviewed in the United States on March 15, 2025
great product fast shipping
Customer
Reviewed in the United States on February 3, 2025
Works, easy to use, almost a surprise at the rapid removal of slug from brass.I would definitely recommend this product and would buy it again but I'm guessing i will never need to. I am very pleased!
Mari Thornburg
Reviewed in the United States on January 31, 2025
Works well
Customer
Reviewed in the United States on January 21, 2025
Pulled the bullets with no problem.
scott h.
Reviewed in the United States on January 13, 2025
This worked amazing. Much better than the hammer way.
Ger R.
Reviewed in Canada on December 12, 2022
good stuff thanks
JyssHarley
Reviewed in France on September 11, 2020
Tout est dans le titre
Sebastien Theriault
Reviewed in Canada on February 16, 2020
Has it sahould be!
Jman
Reviewed in Canada on February 1, 2020
Works like it says
Dougie1
Reviewed in Canada on November 15, 2020
Works well in the cam lock
Steamboat Jack
Reviewed in the United States on February 24, 2017
It works, but.... Unlike with reloading dies, the ram of your reloader can't be full stroked up to end of travel. The correct size shell holder is put on the ram of your reloader. The correct collet is put into the cam lock bullet puller and the puller is screwed into the die holder at the top of the reloader. I screw it in until it just protrudes out of the threads. The cartridge that you want to pull the bullet from is put in the shell holder. Then, slowly raise the ram until you can feel the collet just touch the case neck. Next, lower the ram a fraction of an inch and lock the cam onto the bullet. Finally, lower the ram to pull the bullet. It works, but you have to pay attention to get the bullet just right in the collet. Too far in and you will collapse the case neck down. Not far enough and the bullet will slip. Good luck!
Recommended Products