Your cart is empty.
Your cart is empty.
The Atwood 37697 is a Hydro Flame replacement motor for Atwood furnaces. Works with furnace models 85-IV 25, 85-IV 31.
Robin T.
Reviewed in the United States on March 21, 2025
Fast shipping Thank you
Alfredo Morales
Reviewed in the United States on September 13, 2024
This motor was a perfect match to the original one in the heater. I had to replace both heater motors in my RV but the first was a little different but made it work. This one fit perfectly
Irwin Patkau
Reviewed in Canada on July 26, 2024
I had never had to repair anything like this before, so I watched a ITune how to video beforehand (and during install).Was the right replacement for our older model RV (and is working great).Armed with the right part and tools, it was really quiet a simple repair.
Jody Cote
Reviewed in the United States on June 6, 2024
Worked perfectly as a replacement in my furnace.
OG
Reviewed in the United States on March 15, 2024
Was cheaper than ordering from camping world and easy to put in
E. M.
Reviewed in the United States on September 29, 2023
This was exact replacement for the original motor. It fixed the problem with noise and squeak. It was not very easy to get the old motor out and put the new one in, just FYI, not a problem with this motor's function.
Customer
Reviewed in Canada on October 23, 2023
Works perfectly and much quieter than old one. Good price and delivered quickly.
Jim McCaffery
Reviewed in Canada on January 25, 2023
I replaced the fan motor in the furnace in my motorhome. It worked well.
somewhat satisfied
Reviewed in the United States on June 28, 2022
The new motor works and appears to be a factory exact replacement. The motor that came with the used unit was starting to fail and therefore was very noisy. The new motor is substantially quieter but time will tell whether is this a long term improvement. The overall movement of air to the floor registers appears to be improved. Installation was a pain in the neck and I did not take enough photos of the original connections (nor make sufficiently detailed drawing of the wiring) to make this an easy installation. That said, I was able to pull schematics on line so that I was able to properly install the unit.
Bikenut
Reviewed in the United States on June 26, 2022
Genuine replacement part for HydroFlame furnace without being gouged. Easy installation took less than 30 minutes with no need to disturb the gas valve.
RICHARD
Reviewed in Canada on April 30, 2021
Perfect, My motor died at the end of the camping season was not impressed started looking for a new furnace which wasn’t in the budget but my trailer is an 1988 model I was amazed had it installed and works great so thankful for this saved me a ton of money
Mark seven tenn
Reviewed in the United States on January 2, 2019
Installation was relatively easy through the outside access to my RV furnace. Used my phone to snap pictures of wiring and various stages of disassembly. The only tricky part was reaching the spring clip to release the squirrel gage fan from the shaft. I used needle need pliers with a 90 degree end (from Harbor Freight) to reach into the fan to compress and release the clip. The replacement motor works perfectly and the bearing noise is gone.
Bruce
Reviewed in Canada on April 17, 2019
Motor fit just like old one with a little longer wires. Very quiet running .Note: Needed a long (6 inch) Allen key. Size 1/8 inch to remove fan blades set screws.
Recommended Products