Your cart is empty.
Your cart is empty.' Gasket Sealant, Adhesive/Sealant, 200mL, Blue, Temp. Range -50 to 250 C, Full Cure Remains Tacky, Application Time 10 min., Non-Setting, Non-Hardening, Increased Adhesive Properties Over Universal Blue, Gasket Material '
Ron
Reviewed in the United States on June 2, 2024
Haven't used it yet.
Dan P.
Reviewed in the United States on November 6, 2024
Excellent sealer for aluminum cylinder heads that may have imperfections to their surface finish. Expensive, but worth it.
Ron Thompson
Reviewed in the United States on January 1, 2024
30 year engine builder...this is fuel and oil resistant..silicone is not!!..this is nonhardening. If you can't seal your intake gasket and you have eliminated machining problem this is your best option on.intake ports on sbc or bbc or similar. RON
leo caesar
Reviewed in the United States on September 6, 2023
I use this product on metal head gaskets when rebuilding older engines. It works great.
John Sims
Reviewed in the United States on November 29, 2023
Not used yet
B Jenkins
Reviewed in the United States on September 22, 2022
I've used this for years. I came across it after a head gasket failure on an old Jeep - the copper spray wasn't working. It's now been5+ years since I replaced the head on that Jeep, even with a temporary repair to the water jacket. I used it again on my 2005 Jet boat, which was a temporary repair again, rather than shelling out $50 for a new gasket. This stuff works great, and is easy to use. Clean the surface you're joining, spray the gasket - let dry 10 minutes. Spray the other side. Watch where you spray it (I use an old box) - because it'll make everything sticky.
harvi
Reviewed in the United States on February 19, 2016
The media could not be loaded.
Recommended Products
$108.00
$ 50 .99 $50.99