Shopping Cart

Your cart is empty.

Your cart is empty.

Hypertech 730126 In-Line Speedometer Calibrator

4.7 (1) Write Review
Free shipping on orders over $29.99

$233.70

$ 99 .00 $99.00

In Stock
  • In-line module to correct the speedometer for non-stock tire sizes and/or rear gear ratios
  • Installs easily to the factory wring harness - No Splicing Required
  • Perfect for vehicles with computers that don’t allow for tire size and/or rear gear ratio correction
  • No limitations for increasing tire height or rear gear ratios
  • Easy installation
  • Fit type: Vehicle Specific


When installing tires that are larger or smaller than original equipment tires, and/or installing a ring and pinion gear set with a different rear gear ratio, the Speedometer Calibrator allows you to correct speedometer readings. The vehicle’s computer calculates your vehicle’s speed based on the diameter of the stock tires. If you’ve installed taller or shorter tires, or changed the rear gear ratio, the vehicle’s computer doesn’t know how fast your vehicle is going. As a result, the speedometer readings will not be accurate as required by law. Using the USB cable connect the In-line Speedometer Calibrator Module to your PC and enter the new tire height and/or rear gear ratio. Next, disconnect the factory connector to the instrument cluster behind the dash, snap in the Speedometer Calibrator Module, reconnect the cluster, and you’re done In a matter of minutes, you can accurately correct your speedometer readings.


Shawn McCoy
Reviewed in the United States on March 18, 2024
After installing the in-line speedometer it immediately corrected my speedometer after lift and install.