Your cart is empty.
Your cart is empty.Made of steel and has a folding tip to minimize the damaging effects of impact, reducing the chance of damaging your transmission or shift shaft. Stiffer design eliminates that sloppy feeling of stock levers for more positive shifting response. Won’t let the bike jump out of gear when the lever hits an obstacle. Cheaper and more durable than stock shift levers. For: Suzuki DRZ400 00-07, RMX250 89-98; Kawasaki KLX400 00-06.
warren
Reviewed in the United States on January 18, 2025
Foot peg was bent too far backwards about 15 degrees. It fit so poorly that I bent the old one back into usable shape rather than use this. I did not notice a significant difference in the stiffness of this as compared to stock, though that could be from the aluminum work hardening after being bent. I had another poor experience with the IMS fuel tank and will not buy another one of their products.
Mark
Reviewed in the United States on January 17, 2024
Nice upgrade for my DRZ. I do a lot of off-road and this is definitely more sturdy.
Michael Davis
Reviewed in the United States on June 11, 2018
Seems well-made, but the shape does not give much clearance from the counter sprocket cover. You can basically only put it in one position.And while mine unlike the pictures has the bolt on the BOTTOM (was a nice surprise when I opened it) the bolt goes in at an angle that points it right at the frame. I still had to use a wrench.Don't know how it compares to stock, my bike came with an MSR +1" which I did not like at all. I'll definitely keep the IMS over that, but may end up modifying it or finding one that allows more adjustment.Update 7/8/18 - After a few hundred miles with this shifter installed, the position is perfect for me and fixed the shifting issues I was having. That's for me with my boots on my bike, YMMV.
Darryl Marshall
Reviewed in the United States on June 1, 2018
Fits great on my drz400. Looks slick and back isnt so sharp to crack my casing in the event of a fall.
glenn fisher
Reviewed in the United States on May 25, 2018
This shifter DOES NOT fit a drz400. I took a large rock and bent it to make it work. It isn't quite right but still is better than stock. If I can find another steel shifter I'll probably switch it out.
Carcajou
Reviewed in the United States on July 16, 2016
Good little shifter, rounded in the back to save your engine case, easy install, quLity product! Same lenght as the OEM one but better in every way!
Alex S.
Reviewed in the United States on June 8, 2015
Eliminated my 2nd gear slipping. The clamp bolt is a little beefier than stock, and it has way better shifting response. The tip has a rubber cover similar to stock as well which my leather boots appreciate.
CR73
Reviewed in the United States on December 17, 2012
Got this for my 2008 DR-Z400 Super Moto and I'm very happy with the quality and finish of this shift lever. It was a bit of a struggle to install, but it's the design of the bike and not at all the fault of the lever. Suzuki has a few things in the way on the DR-Z's that make it a bit of a blind installation without putting the bike on its side. I have used several IMS products in my years of riding and their quality has always been top-notch.
Recommended Products