Your cart is empty.
Your cart is empty.
For Detroit Diesel 60 Series Injector Cup Remover Installer Tool
Fitment
For Detroit Diesel 60 Series, alternative to J-46904 & J-48824.
--Use J-46904 for screw-in stainless cups 240-1039 23538840 240-1035 23533148.
--Use J-48824 for screw-in stainless cups 240-1045 23534745 23538829.
Features
- Function: Alternative to J-46904 & J-48824 to work in an easier way to save your time and money.
--Meterial: Advanced blackening solid steel process, durability and anti-corrosion. Ultra-precise design meets the requirement of high precision and hardness and a much longer service life.
--Works on screw-in stainless steel cups to remove or install the injector cups.
Using Instruction:
1. Install injector tube service tool (J-46904 or J–48824, ) into injector tube.
Ensure tabs are engaged in tube and tool is completely seated.
2. Turn tool counterclockwise to remove the injector tube from the cylinder head.
Observe and record locations of any shims installed under the injector sleeve.
3. If using J-48824 to remove the injector tube, turn the center bolt to expand the fingers located on the end of the tool.
NOTE: When the injector tube is removed, check the bottom of the tube and tube bore to see if a shim has been installed.
If a shim is installed on the removed injector tube and the tube is being replaced, the new tube will also need a shim.
The shim is used to adjust the height of the injector cup after the cylinder head has been resurfaced
Package Included
1× J-46904 Nozzle/ Cup/ Sleeve/ Tube Remover Installers
1× J-48824 Nozzle/ Cup/ Sleeve/ Tube Remover Installers
Milton Maradiaga
Reviewed in the United States on January 21, 2025
Excelente producto y material
Westend
Reviewed in Canada on July 18, 2024
The tool is made of good quality and is what i expected for the price. Works very well
Customer
Reviewed in Canada on January 2, 2024
No problem
Joe H.
Reviewed in the United States on November 6, 2023
WORKED GREAT
New Best Truck
Reviewed in Canada on November 15, 2023
works well
Matt M.
Reviewed in Canada on October 21, 2023
Material is waaaay too soft, broke on first use, didn't get a single injector cup out. Don't waste your time and money on this garbage.
RIVERBOY
Reviewed in the United States on January 19, 2023
These worked good for installing sleeves. Not strong enough for sleeves that are stuck. Installation torque is 33#. The ones I removed took 300# or so. I hard to make my own tool and use a impact after freezing.
Mechanik
Reviewed in the United States on December 7, 2022
Made out of chinesium.
Jon m
Reviewed in the United States on January 20, 2022
Remove and install cups on a 14L series 60 detroit
David Pollock
Reviewed in the United States on June 8, 2021
Poor quality, first time use ,tool chip then became non useable soft metal
Josh
Reviewed in the United States on June 15, 2021
There made too cheap broke first time used them
Recommended Products
