Shopping Cart

Your cart is empty.

Your cart is empty.

J & O Carts Parts Aluminum Diamond Plate Rocker Panels for Jeep TJ (1997-2006), Silver, Left & Right Lower, 1 Inch Bend & Cut Out Set of 2

4.6 (3) Write Review
Free shipping on orders over $29.99

$81.95

$ 35 .99 $35.99

In Stock

About this item

  • Fits JEEP TJ DIAMOND PLATE ROCKER PANELS with 1 INCH BEND & cut out set of 2
  • FITS 1997 to 2006
  • 3003 Highly Polished .063 gauge Aluminum Diamond Plate
  • Hand Made in the U.S.A.


Will not fit the Unlimited/LJ. NO NEED TO REMOVE YOUR FENDER FLARE OR EXTENSIONS WITH THIS SET JUST SLIDE THEM RIGHT BEHIND THEM. MY ROCKERS RUN A FULL 5 3/4 INCHES TALL, THIS SET HAS A 1 INCH BEND ON THE BOTTOM SO IF YOU HAVE SOME RUST OR ROT THIS WILL COVER IT AND LOOK GOOD DOING IT. PLEASE NOTE: TO INSTALL YOU CAN USE RTV CAULK, 2 SIDED TAPE, SCREWS OR RIVETS. TUCK ROCKERS UNDER FENDER FLARES ON BOTH ENDS, HOLD OR CLAMP IN PLACE AND INSTALL RIVETS OR SCREWS.


Josh Willard
Reviewed in the United States on September 6, 2017
Looks good on my Jeep
Kermit kitchen
Reviewed in the United States on June 9, 2017
Easy to install looks good
ziggy
Reviewed in the United States on March 24, 2017
It may be my jeep, but the cutout for the extension didnt match up. I ended up cutting them off and installing the rest of it. Other than that issue it was a solid piece.