Your cart is empty.
Your cart is empty.Product Description
Product details
- Pre-installed durable O-ring, no need to buy a new one for installation.
- The unique Injection hole design makes the fuel injectors have a good atomization function and burn more fully.
- Electrical connectors manufactured in accordance with OE standards can be plug and play.
Fitment
Compatible with Nissan vehicle
Compatible with Nissan Pickup Base 2.4L1995
Compatible with Nissan Pickup XE 2.4L1995
Compatible with Nissan D21 Base 2.4L 1990-1994
Replace Part Number:
16600-86G00 16600-86G10 JS21-1 35-80798I40
Why choose JDMON fuel injector?
＊Atomization standard
＊Accurate oil control
＊Intelligent control
＊Energy saving
When your beloved car has the following failures, please check and replace the fuel injector.
Unusual vehicle vibration
Engine fault light is on
Difficult to start the car
Increased fuel consumption
Steve Harder
Reviewed in the United States on January 17, 2023
Wrong O-rings, they swelled and leaked from the gas
J. Taylor
Reviewed in the United States on August 3, 2021
Had to re use the old o rings but They seem to work fine after 1 day of driving, will update if they fail or have issues.
SJ
Reviewed in the United States on August 3, 2021
I got these because my truck was idling rough and would sometimes flood out while shifting up, and also sometimes would flood out after being shut off. I assumed I had a leaking injector so I thought for the price why not. Well after installing them the truck ran even worse. Turned out that I had a bad connection on my temperature sensor. After cleaning the terminals in the temp sensor my truck ran better but still has a rough idle, so these are still not as good as original that had over 300,000 miles. If you want to use in a daily driver I would look for something a little higher quality, if it is for something that will be used occasionally and your hoping to save money, they will get you back on the road.
The buyer
Reviewed in the United States on May 11, 2021
These were hot garabage!!!!!!!!!!!!!!!Do not purchase. I repeat do not purchase. I have a 1993 Nissan hardbody and they would not flow right. They would bog down under acceleration and backfire. I replaced all vacuum lines, fuel filter, check valve, pcv valve, fuel pump, and air filter. Luckily I kept my stock injectors. I put them back in and all was well. Maybe they work well for other vehicles but if you have a hardbody, these are a no go. To late for a return so that’s $40 down the drain. Take my advice or you will be writing a review like mine! Also the o-rings are to big for the intake manifold they do not seat flush. Yes I tried with stock o-rings as well, got the same result. Poor acceleration, fuel mileage, and lugging uphill.
smart shopper
Reviewed in the United States on March 27, 2021
The injectors worked but you have to use old o rings. The o rings that come with them are to big.
Cheryl
Reviewed in the United States on April 13, 2021
Worked great in my 1990 Nissan hardbody with the KA24 motor. Cleared up my misfire and got the truck running smooth again.
Chris d.
Reviewed in the United States on October 4, 2020
👍
Recommended Products
$76.96
$ 31 .99 $31.99