Your cart is empty.
Your cart is empty. APPLICATION：
It's called a V-belt because of its "V" shaped cross-section. All belts wear out over time and need to be replaced.
-V-belts can be found in driving mechanisms, such as engines in air compressors, fans, and pumps.
-Wrapped V-belts give premium belt performance. V-belt is the rubber belt that drives the alternator, air conditioning compressor, power steering pump, and water pump.
ABOUT THIS PRODUCTS/FEATURES：
-The belts are constructed of highly engineered, high-performance components. A V-belt is a wedge-shaped belt made of rubber compound and reinforced with tension cords specially designed to transfer power into motion.
-The outer fabric wrap is treated with oil and heat-resistant, engineered synthetic rubber compound, specifically compound for excellent wear resistance, proven through thousands of hours of testing.
-The wound tensile cords are specially engineered, twisted, heat-, chemically set, neoprene rubber material.
-The body rubber compound is a highly engineered synthetic rubber compound.
SPECIFICATION：
Model: K-31
Pitch Girth: 31 Inch
Width: 8mm
Thickness: 6mm
Material: Rubber
TAKE NOTICE OF/TIPS:
-When installing the V-belt, ensure proper tensioning and alignment with the pulleys. Check for any signs of wear, cracking, or damage regularly, and replace if necessary.
E Simms
Reviewed in the United States on March 17, 2025
as advertised
Tiffany Gumino
Reviewed in the United States on August 9, 2024
I purchases this to replace an agin belt on a drill press. Replaced belt had K26 printed on it and the drill press lost belt size at k26.I tried very hard to install the belt around both pulleys, having changed speeds in past, but no matter what, it would not go on.Finally I gave up worried that even if I was able to get it on eventually, it would ruin my drive or motor bearing with such a high load.
Customer
Reviewed in Canada on May 27, 2024
It is as advertised and seems to be good quality
Garry
Reviewed in Canada on January 15, 2024
v belt fit perfectly for my drill press
Unknown
Reviewed in the United States on December 22, 2023
Works as expected and fits WEN 4210B-002 and 4210B-005 pulleys I am using on Skill DP9505-00.Original belt is 8mm and this one is 7.5mm but seems fine.
Kyle Perkins
Reviewed in the United States on November 10, 2023
This belt has the exact same part number as the belt that came with my Delta drill press. It will not fit properly it is to short. This belt came in a box with the correct part number as well. It did not look right when I took it out of the box but I tried it anyway. There is no way this belt will fit my application, It's a size or two short with the tension adjuster completely backed out.
Recommended Products
$20.10
$ 8 .99 $8.99
$15.94
$ 6 .99 $6.99