Your cart is empty.
Your cart is empty.316 Stainless Steel Combo Stainless Steel 3/8 I.D Hose Thru-Hull Fitting w/Nut with Gasket for Boats, Yachts, Marine
This solid cast 316 Stainless Steel thru hull fitting has a highly polished flange that makes your boat look great!
and the hose barbs fit 3/8" I.D marine hose. 316 stainless mounting nut included.
These are the original equipment fittings used on many offshore salt water fishing boats!
Customer service
If you have any question, please contact us via Message. All problems will be resolved.
NOTE:
Manual measurement has an error of about 1MM-2MM, please understand it!
SarahE14
Reviewed in the United States on September 8, 2024
Slightly smaller than OEM for 2007 Malibu LSV outlets but worked great to hard plumb piggyback ballast bags.
Bobby
Reviewed in the United States on March 8, 2024
good quality
Stephen J Wire
Reviewed in the United States on November 18, 2024
Description says product is 2.95 inches long and 1 1/2 inches of threads. The product that arrived was about 2.5 inches long with about 1 inch of threads. No threads made it through the hull which was just under 1 inch thick when using the gasket. The product itself was good quality and machined nice, just not the length they advertise.
M. Hubertson
Reviewed in the United States on December 27, 2023
The dimensions were off. Smaller then stated.
Old school
Reviewed in the United States on October 27, 2023
I like the thickness of the metal and stainless finish
Kevin
Reviewed in the United States on July 20, 2022
Strong looks nice and fits perfect
Dawn Delahunt
Reviewed in the United States on February 5, 2022
rust stains after 1 season in salt water I now have to replace.....
RD
Reviewed in the United States on August 28, 2021
These worked perfectly. They looked great, easy to install and has little tabs inside to hold ,I used the end of a pair of pliers to keep the unit from turning while tightening the nut on the inside.
Recommended Products
