Your cart is empty.
Your cart is empty.Kolpin KXP Boottector Bracket for UTV fits the gun boot IV and the gun boot 6.0 cases only.
DanaC
Reviewed in the United States on March 4, 2025
Bought this to attach to my rhino so we can carry the chainsaw in a safe compartment. Easy to install. This is such a sturdy product. I Know that this will last a long time. And it looks great attached to the side.
David W
Reviewed in the United States on December 30, 2024
Perfect to mount the gun boots on side of my UTV love them
Jody
Reviewed in the United States on August 8, 2023
works as should
Gus_19
Reviewed in the United States on July 5, 2023
Advertised as Polaris Lock and Ride. Maybe for the Polaris Ranger, but not seamless for the Polaris General. For one, the "sleeve" doesn't just slide over the bed rail as it's a tad too narrow and two, the hole for the lock and ride plug doesn't line up. I ended up widening the hole and will eventually drill a new one to reposition. Next time, advertise for just the Ranger if that's all it works with.
Matt
Reviewed in the United States on March 15, 2023
Works great with the Polaris lock and ride. Hold and protects guns great.
Bob M.
Reviewed in the United States on November 23, 2023
The bracket is not wide enough to fit over the bed rail. It says it fits all polaris lock and ride beds, but it does not.
Thomas
Reviewed in Canada on October 13, 2023
Works fine
Rodney Foss
Reviewed in Canada on September 30, 2021
Fit my 2012 Ranger 500 perfect.
James b Harris
Reviewed in the United States on March 11, 2020
Like the way it goes on and off easy. Shakes quite a bit when on rough ground so I put a bungee cord on one end.
Justin
Reviewed in Canada on December 8, 2020
Poor design, very wobbly . I had to weld it up and make it more safe for polaris ranger.
Alan Ecklund
Reviewed in the United States on December 18, 2018
This gun boot works great and provides a solid, safe way to transport my rifle on my Polaris Ranger. Would highly recommend this combination products.
spotter2
Reviewed in Canada on November 24, 2014
The bracket fit fine in the box of my Ranger 800. It will require some foam tape to stop it from pivoting in the mount. But, I am content with the overall fit. The original box it came in was damaged and fortunately, no pieces were missing.
Claude E. Gauvin
Reviewed in Canada on April 24, 2014
After assembling the Boottector Bracket, it fitted very well on my Polaris Ranger 500 EFI.I truly recommend this Kolpin 20351 Kxp Boottector Bracket
Recommended Products
$58.50
$ 25 .99 $25.99