Your cart is empty.
Your cart is empty.Honda CR style kill switch replaces OEM item numbers: 35130-KT0-670/35130-KZ3-860. Replace a worn out or non-working dirt bike kill switch with this OEM replacement kill button. 17 inches long direct two wire plug-in into the stock wiring harness. Fits 7/8 handlebars. Kill switch is normally open and provides a connection to ground when operated.
maneloxz
Reviewed in the United States on June 19, 2024
buen producto, similar al original
tel
Reviewed in the United States on May 25, 2024
Nothing more to say it does the job at a great price.
Christian de Schweinitz
Reviewed in the United States on February 20, 2024
This doesn’t always work. Have to wiggle and push hard to get it to kill the machine. I returned it and got the switch style. The factory Honda push button kill switches always worked much better. This is low quality
Clayton Cart
Reviewed in the United States on October 17, 2022
The picture advertised for the kill switch is the exact replacement I was expecting to receive. However, when I received it, it did not have the male and female ends on the wires and the wires were short. I had to splice and heat shrink to the old wires that were on my bike. I was expecting to be able to just plug the male and female ends in, then attach the button to the handle bars, but that was not the case here. What should have taken 5 minutes to install, took much longer, as I didn't have wire strippers or heat shrink equipment available when I wanted it installed. The product works fine, but it is not compmetely what is shown in the advertised picture.
Phillip mamouf wifarts
Reviewed in the United States on February 20, 2020
This push-button Killswitch replaced the factory rocker style Killswitch on my son's bike, fit well, install was easy, looks great and functions as it should, even the wiring colors matched the bikes harness. I purchased two, one for each of my sons bikes.
Seth Masia
Reviewed in the United States on May 31, 2019
Serviceable. Easy to install, works like the OEM unit but wire connect at the button end don't look as waterproof as the Honda original.
TK's
Reviewed in the United States on November 15, 2015
Good quality for a "cheap" replacement part. Electrical connectors plugged right in. Leads are slightly shorter so I had to route behind the bars instead of in front. One connector unplugged itself during the first ride because it was front routed. I am happy with this kill switch and would buy again. Installed on 2003 Crf450r.
Recommended Products
$49.19
$ 24 .99 $24.99