Your cart is empty.
Your cart is empty. Specifications:
Board size: Approx. 25x12mm
Weight: About 2g
Adaptable voltage: 3.6-16V (more than poked with high voltage steering gear)
Output supply voltage = input supply voltage
Output: General PWM steering gear signal
Output signal frequency: 50Hz (if you give 300Hz signal as input, the output is also 50Hz. Generally, the remote control output servo signal is 50Hz, high frequency is used in special occasions)
Applicable steering gear should support 500-2500us 180 degree turn steering gear (most steering gear support 180 degrees, if the servo does not support (for example only supports 800-2200us), be careful when adjusting the rudder angle. If the signal exceeds the range, the steering gear may be damaged. In addition, some steering gear are close to 180 degrees, so be careful when adjusting to the maximum)
The difference between delay and slow speed:
Delay: The servo does not move. After the delay time, it will execute immediately. (Maximum delay 4 seconds (the knob is full))
Slow speed: The servo executes immediately, according to the set slow speed. (The speed can be slow enough to turn 180 degrees to take more than 20 seconds)
The knob is adjusted to the minimum, which can remove the function of delay or slow speed. The device is only used as a positive and negative and rudder angle controller.
Steps for usage:
Turn the time knob to the minimum to remove the delay function (turn it counterclockwise) Insert the converter between the receiver and the steering gear
Adjust the range knob and operate the remote control at the same time to confirm the front and back of the servo and the size of the rudder angle
Then increase the time knob to increase the delay
Package includes:
1x Converter
Note:
Some steering gear meet the limit plate before it reaches 180 degrees. Do not force the motor to stall.
After the analog steering gear is powered on, it may vibrate when there is no signal
Albert
Reviewed in Germany on February 26, 2025
Sogar ein Schraubendreher liegt bei, saubere Platine. Nur anfällig, weil direkt in Versandtüte, ohne Schutz,
aksman
Reviewed in the United States on June 27, 2024
This circuit allows you to adjust the speed (slow down) of a servo motor. Simply solder the 2 rectangular pads on the rear together.
Electrico
Reviewed in Spain on March 21, 2024
Simplemente un muy buen articulo , tanto en regulación de recorrido como de variador de la velocidad del servo⭐️⭐️⭐️⭐️⭐️
James E. Shander
Reviewed in the United States on February 21, 2024
Bought two and both work perfectly even coming with a little extra screwdriver. Quality made
GIANLUCIO M.
Reviewed in Italy on September 26, 2023
Quello che cercavo per usare servi ad alta frequenza su entrate a bassa.
Heimwerker
Reviewed in Germany on November 17, 2023
Habe es installiert, hat leider nicht überhaupt funktioniert. Rücknahme war allerdings kein Problem.3 Sterne für den Verkäufer
mpsphxaz
Reviewed in the United States on November 11, 2023
When you solder the tabs together it's a speed reducer, works perfect on the Redcat COE Hauler to slow down the air ride servos!
Recommended Products
