Your cart is empty.
Your cart is empty.-Bruce-
Reviewed in the United States on January 3, 2025
My VNA says these resonate at about 790MHz, at 915 their SWR is above 3. I had to shorten by nearly 2 inches to resonate around 900. (Very tough steel cable element, use Dremel cut off disk.)For comparison, the similar Muzi Works ones measure as almost perfect (915 @1.1 SWR).
Thomas
Reviewed in the United States on December 26, 2024
The connectors plugged right into a LoRa dev board I picked up a few months back, unable to measure just how much of a gain I get but it's noticeable.These also work for more than just 915mhz, using the 2nd one on another radio with a SMA connector just fine in the sub-ghz range. Great little antennas!
Robert
Reviewed in the United States on December 18, 2024
This is a simple product. There's a short jumper that goes from our Meshtastic-style LoRa board to a chassis-mount "rubber duckie" single-pole antenna. While the bendy part is quite bendy, there's not an additional joint, so if you're drilling, drill with the hole on the TOP so it can go UP and not on the back, expecting a 90-degree swivel joint in the antenna as there isn't one. (None such is claimed.) The first pic doesn't make it clear. The big part on the left is bendy and springy, like an antenna you'd see on a police car. The second part is just a piece of wire that attaches the case SMA connector on the antenna/case to your IPEX on the board. It's just unfortunate that the pictures look so similar.The needed hardware for a case mount installation is all here, it seems.I can't actually test effectiveness, as I currently have only one functioning LoRa unit, and it's determined to die of loneliness and never actually connect to those peer nodes I was hoping to see.Five stars for being what it says it is and being a good value compared to similar products.
Recommended Products
$10.77
$ 4 .99 $4.99