Your cart is empty.
Your cart is empty.Product Description
Compatible with Picatinny
Dual torque fixation
High brightness optical fiber
Suitable size
Thomas Porter
Reviewed in the United States on January 5, 2025
These are decent sights. Good viewing optics. I however returned mine. To low for the application I needed.
Aquavia
Reviewed in the United States on July 13, 2024
Product was delivered very fast, good quality, and exactly as described, definitely worth the purchase price.Thanks
DC
Reviewed in the United States on June 10, 2024
I wanted to put these on a break-action O/U with a rail - I didn't have high expectations, but for about $20, it was inexpensive enough to experiment. The sights work fine - Nylon, yes, but they'll easily hold up to 12GA recoil (they are so light, after all). The problem was my application - there's just not enough rail to get them far enough apart for any useful degree of accuracy (they're no better than the bead, as close together as they are).I think I might have a full-length rail for my pump, I may try it there. One thing I know is that these are FAR too low for an AR.
Brad
Reviewed in the United States on May 25, 2024
They are sites and they work but they are very cheaply made and the screws already stripped out of it so I had to put bigger screws in them plus they are super short so you would need a raised pic rail to use them
Anime58
Reviewed in the United States on December 7, 2024
Easy to install and the florescent sites are great too.
R. Christian
Reviewed in the United States on October 4, 2024
Order The green for my green rifle got black otherwise they seem good.
Chip
Reviewed in the United States on April 28, 2024
TPRCOL Low Baseline fiber front and rear sight $19.90Reasons for less than 5 star review; front sight doesn’t fit my handguard rail and rear sight is a very tight fit on receiver rail. I measured and it should fit, but I think it will require hand fitting of the base for the sights to fit.I purchased looking for high visibility sights, liked these. However, these do not have any windage adjustments so cannot adjust POI. You're stuck with where it hits the target.Also, this may not be deal breaker, they don’t use cross bolts to secure on rails. Instead they have set screws that screw down into the slot for the cross bolt. I don’t think that’s an issue, just tighten as needed.For these reasons I’m returning with less than 5 stars.It otherwise appears to be quality material and manufacture. Comes boxed with instructions and key to tighten set screws.Apr 28, 2024
Bob S
Reviewed in the United States on April 22, 2024
I tried the T1 version of this product twice (see my review) but they didn't work. I was hoping the T2 fiber optic would be great but it fell far short. The idea is great but the design and material are just not working. The attachment screw stripped out again. I couldn't get the screw up enough to get it off the rail so I had to cut it off (see picture) and while doing that I scratched the finish on my PC Charger (see picture). I really wanted this product to work but for now it's just not.
Recommended Products