Your cart is empty.
Your cart is empty.Oil Pressure Sensor Adapter for GM LS Engine Swap Male M16x1.5 AND M12x1.5 to Female 1/8 NPT . 1/8" NPT taper pipe thread port in the rear of the fitting allows for common sensors or plumbing fittings.
Denise F.
Reviewed in the United States on June 5, 2024
I have a John Deere tractor and needed a fitting for a temperature sensor . this fitting worked great no problems 5 Stars rating
mark
Reviewed in the United States on May 10, 2024
Wanted to hook a old school temp gage and it dose not work
Jeffrey pereira
Reviewed in the United States on March 8, 2024
Exactly what we needed
jesse holland
Reviewed in the United States on January 18, 2024
Did exactly what i needed it to bolted to passenger head at back for an added temp sensor for a ls swap i did
Wes
Reviewed in the United States on August 22, 2023
Just what was needed. Came nicely packaged. They include aluminum washers. The threading external and internal is clean. They are aluminum tightening into aluminum which prevents galvanic corrosion but careful on the torque spec so you don't strip them out.
william Thomas
Reviewed in the United States on August 11, 2023
I used the adapters when swapping an lq4 in my s10. they seal well and have not leaked. they seem well built for the cost and adapting everything correctly. buying a set for my c10 swap.
Rafiki
Reviewed in the United States on July 15, 2023
They actually work and fit well in LS1
2centwurf
Reviewed in the United States on October 25, 2023
This is advertised as fitting a 2005 Chevy LS head. It fits the head loosley and the compression washer is NOT a compression washer. Pressure check of cooling system exposed a leak at the left rear head, i.e., this fitting. Moderate tightening of the head to sensor adaptor resulted in the adaptor twisting off with the threads left in the head. Removed the broken portion from head, used a brass adapter and no leak. This is a cheezzie Chinerzze product.
Recommended Products
