Your cart is empty.
Your cart is empty.Product Description
Arch Morrison
Reviewed in Canada on August 4, 2024
I am using these for my fish pond aeration to connect self sinking lines to bubbler lines and they are working great.
Customer
Reviewed in the United States on July 31, 2024
Well made good product.
Carlos Mendez
Reviewed in the United States on March 4, 2024
Avía comprado otros antes en home depot pero no me gustaron porque tienen algo en medio que no deja que pega en mi caso la manguera de aire y estos si entonces creó que dura el pegamento más tiempo que los otros
Erric Crutcher
Reviewed in the United States on March 17, 2024
Used them to repair gas line on a torch. They were just the thing i needed. No leak and good hold under pressure.
ネルソン
Reviewed in Japan on February 14, 2024
差し込みが長くホースにしっかりはまり漏れも外れもありません
Customer
Reviewed in the United States on December 23, 2024
Just a description says and works great
Chris
Reviewed in Canada on December 20, 2024
Thanks for a great product.A+++++
Wolfgang
Reviewed in Australia on November 8, 2024
Very good quality, accurate and good detailed barbs.
Oz
Reviewed in the United States on December 25, 2023
It works for what need.
fuku
Reviewed in Japan on April 24, 2021
水耕栽培のホース同士の接続に使いました。内径8mmという中途半端なものだとホームセンターでも高価なものになってしまうし、機械加工で作るにしても高いです使い勝手的には問題ありません。いい商品です
BrianInAz
Reviewed in the United States on July 28, 2020
I had a plastic fitting on my fuel injection return hose break. The dealer wanted $190 for a new assembly.I looked on the Sprinter forums and this was a very common problem. A couple guys suggested repairing with some barbed couplers. These fit perfectly and are strong enough to not ever break like the plastic one did. The hole inside is large enough for proper fuel flow which is important for the computer which monitors fuel flow rate through those lines.
BotMan
Reviewed in the United States on May 29, 2020
I used one of these to replace the plastic tube which originally connected my windshield washer fluid feeder hose (runs from the tank in the engine bay to the back of the Jeep) to another hose at the back of the hard top which leads to the rear wiper's spray nozzle. After a few years, that OEM plastic tube started to slip, and I ended up with washer fluid all over the inside of the Jeep's rear storage area when it slipped off entirely. Played with a replacement DIY plastic tube for awhile, until I bought these brass tubes with barbs on either end, which fixed the problem permanently. If I ever feel like taking the hard top off, I should still be able to disconnect this with a little effort, but until then, the fluid flows well, and only to the outside of the rear glass where it belongs, not all over the groceries. :)
Ken Holley Jr
Reviewed in the United States on November 19, 2020
worked they should
Recommended Products