Your cart is empty.
Your cart is empty.
- Detection Object: Magnetic metal(the detection distance decreases when it is non-magnetic metal).
- Delay Distance: 10% below of the detection distance.
- Supply Voltage:DC10-30V Impulse (p-p)10% below.
- Comsuption Current: 13mA below.
- Control Output: 200mA below.
- Loop Protection: Reversal connection protection,surge absorption,load short-circuit protection.
- Ambient Temperature & Humidity:During operation, storage: individually-30～＋65℃(no freeze ,no drew ), During operation,storage:individually 35-95%RH.
- Insulation Impedance: 50MΩ above ( DC500 megameter ) between charging part and shell.
- Withstand Voltage: AC1000V 50/60Hz 1 min. between charging part and shell.
- Temperature Influence: Temperature range-30～＋65℃,at + 23℃,± 15% detection distance, Temperature range-25～＋60℃,at +23℃,±10% detection distance.
- Voltage influence: Inside ±15% rated supply voltage range,at rated supply voltage value ,inside ± 10 % detection distance.
Brani P.
Reviewed in Germany on February 7, 2025
== ToP Artikel ==
Chargeit
Reviewed in the United States on January 27, 2025
Got this for my 3d printer. Much cheaper to print up adapters and mount this then buying prepackaged sets. Works as intended.
SDWA
Reviewed in the United States on November 6, 2024
This proximity sensor works as described, and has a slightly larger range than advertised. I liked the serrations on the backside of the mounting nuts to help keep them locked in place. Tested great on the bench, if there are any issues long term, I’ll return to update review. Original review 11-2024.
markus
Reviewed in Germany on January 20, 2021
auf mein sensor steht 10-30vdc 200ma ? nicht das gleiche wie hier. werde ihn testen. wen es nicht geht geht der sensor zurück..... ps eine gebrauchsanweisung wäre hilfreich. welcher der plus pol usw ist.
Kevin
Reviewed in Germany on August 11, 2020
Nachdem ich auf eine Glasplatte (Spiegel) bei meinem 3D-Drucker geupgradet habe, hatte ich mit dem kleinen Sensor von Taiss (LJ8A3-2-Z/AX-5V) leider keine andere Möglichkeit als auf einen größeren Sensor umzusteigen.Der Einbau verlief wie beim alten Sensor, Distanz eingestellt, Z-Offset festgelegt und es wird wieder einwandfrei gedruckt.Kann ich nur empfehlen!
Recommended Products
