J8J70-67903 Tray 1 Kit (pickup roller and separation roller) Removal and replacement User Manual

HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Tray 1 pickup roller

J8J70-67903 Tray 1 Kit

J8J70-67906 Tray 2 roller kit Removal and replacement User Manual

HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Trays 2-x rollers

J8J70-67906 Tray 2 roller kit Removal and replacement User Manual

1:OPEN THE PAPER TRAY TO LOCATE THE ROLLERS

2:OPEN THE PAPER TRAY TO LOCATE THE ROLLERS

3:Tray 2 rollers only: On the back side of the printer, open the rear door.

4:Tray 2 rollers only: Raise the transfer assembly.

5:Tray 2 rollers only: Do the following:

6:Tray 3 rollers only: On the back side of the printer, open the rear lower cover.

7:Tray 3 rollers only: Do the following:

8:Remove the orange separation roller tool from the packaging.

9:LOCATE THE SEPARATION ROLLER

10:Install the orange tool in the separation roller until it snaps into place.

11:Slide the roller to the left.

12:Tilt the end of the tool down (callout 1), and then pull straight out of the printer (callout 2) to remove the separation roller.

13:Remove the orange tool from the separation roller.

14:Locate the pickup and feed rollers.

15:Locate and pull down the blue tab to unlock the pickup and feed rollers.

16:Use the blue tab as a handle to slide the rollers to the left to compress the left blue post until it clicks into place.

17:Slightly move the rollers to the right to free them from the blue post. Make sure that the roller is clear of the black post on the right.

18:Slightly lift up the front of the roller assembly (callout 1), and then pull the assembly away from the printer (callout 2) to remove it.

19:If the left post does not stay in the locked position, press the end of the post left until it clicks into place.

Remove the tray 2 separation and pickup rollers Follow these steps to remove the tray 2 separation and pickup rollers.

1:Align the arrow on the roller assembly with the arrow in the printer, and then slide the rollers into the printer.

2:Slide the rollers to the right onto the black shaft.

3:Confirm correct installation: The white hook on the top of the roller assembly (callout 1) will hook onto a sheet metal plate (callout 2) when installed correctly.

4:Locate the lever on the blue shaft on the left, and then release the lever by pressing upward.

5:Remove the orange tool from the roller assembly by pulling it away from the printer.

6:IMPORTANT: Pivot the tab up and snap it into place against the rollers to correctly lock the rollers in place.

7:Install the orange separation roller tool onto the replacement separation roller.

8:When installed correctly, the embossed arrow on the roller case aligns with the white tab on the rail.

9:Do the following:

• Align the center of the roller with the end of the metal shaft.
• Slide the roller to the right onto the metal shaft until it snaps into place.

ALIGN THE ROLLER AND SLIDE IT ONTO THE METAL SHAFT UNTIL IT SNAPS INTO PLACE

10:Remove the orange tool by pulling it away from the printer.

Due to image upload restrictions, please refer to the attachment for a detailed installation manual.