Shopping Cart

Your cart is empty.

Your cart is empty.

M8 Inductive Proximity Sensor Switch, Non-Shield Type, LJ8A3-2-Z/AX-DC5V, Detector 2mm, 5VDC 200mA, NPN Normally Closed(NC), 3 Wire

Free shipping on orders over $29.99

$6.49

$ 2 .99 $2.99

In Stock
  • Working Voltage: 5VDC; Current Output: 200mA
  • Mounting Hole Diameter: 8mm; Cable length: 120cm/48"
  • Detecting Distance: 2mm±10%; Set distance: 0-1.6mm
  • Output Type: NPN Normally Closed(NC); Non-Shield(non-flush)
  • Detect Object: Magnetic Metal


  • Power supply reversal connection protection; short-circuit protection, can directly connect with PLC
  • Used in common places with medium enviroment resistance
  • Red LED indicates that it's available to detect the sensor operation state
  • Economic and simple operation
  • Widely used, can be substitution of min-type switch and limit switch
  • IP 67 protection

HTK
Reviewed in the United States on December 11, 2024
When the lift is up enough it engages the winch and stops me from overlifting. It works as expected. My only concern is the longevity as I'm not sure it is rated for weather and moisture, but that is not a problem of the product, rather a problem in my not thinking of that before I purchased this. So far so good!
Jon Allen
Reviewed in the United States on November 16, 2024
This probe is pretty unique in that it runs off of as little as 5V. This is really great because it means that you can wire it directly to the logic pins of your mainboard/microcontroller without concern of damaging anything. No need for complicated diode/resistor/multiple voltage setups. Just 5v in and job done.