Your cart is empty.
Your cart is empty.Mazda Housing Seal - M507-17-335A
Ian Sotomayor
Reviewed in the United States on November 9, 2023
For all you diy-ers doing this for your first time, keep the old one, rip the rubber off it and slide it over the rubber of the new one so you can hammer it in.Not sure if needed, but replaced my driveshaft so I thought might as well replace it. Was quite simple and easy. Fit very snug as should and used the old one to hammer it in to make sure it was seated all the way.
David
Reviewed in the United States on November 23, 2022
Was doing the diff and figured why not. Been holding up 18 months no problem. Always go OEM where possible folks.
Erin Joyce
Reviewed in the United States on October 23, 2022
Trans output seal for miata. Best price around
Jordan
Reviewed in the United States on November 13, 2020
Look at the front face of the seal, it will say "top" and "bottom" or "up and "Down. YOU MUST INSTALL THIS CORRECTLY OR IT WILL STILL LEAK. ask me how i know.also, just add a drop of dish soap around the outside to help slide it in. (literally just a drop, do not use grease)bang evenly in circular motion and you're good to go.-fits my 96 perfectly.
Brian
Reviewed in the United States on September 20, 2018
Had to pull the drive shaft on my 05 MSM. Figured I'd replace this gasket while there. No complaints as it fit perfectly.
sandbag
Reviewed in the United States on November 1, 2018
Fast shipping, good price. This is a spare. I discovered something. Whenever I buy a spare part the original part never seems to break! Kind of a reverse Murphy's law, or something. I have a garage full of spare parts. LOL
Jeremy
Reviewed in the United States on September 9, 2016
OEM Mazda seal that worked great in my 1991 Miata. If you are taking the time to change a clutch replace all the trans seals also.
Jamall
Reviewed in the United States on December 13, 2016
Fits
Recommended Products
