Your cart is empty.
Your cart is empty.Backed by superior materials and rigorous testing, MOOG® outer tie rod ends deliver reliable performance you can count on. MOOG problem-solving innovations ensure fast, hassle-free installation.
Sniper
Reviewed in the United States on August 13, 2024
Quality products, fit's great
Donald Hughes
Reviewed in the United States on July 7, 2024
Good part
M. Bustolin
Reviewed in the United States on July 30, 2024
Great quality, truck drives like new again
Eddie Martinez
Reviewed in the United States on July 21, 2024
Envio rápido producto de buen calidad y buen precio
stacey brosamle
Reviewed in the United States on July 11, 2024
Perfect fit 1999 ford ranger 2wd
Miguel Ayala
Reviewed in the United States on April 20, 2024
These were a perfect fit for my 2002 Ford Ranger with Coil Springs. I replaced each side and it only took about 20 minutes. Great quality part. Make sure to add a little bit more grease after the install.
Diego V.
Reviewed in Mexico on March 8, 2023
Todo estuvo en orden y me llegó lo que tiene está publicación
Ronny B.
Reviewed in the United States on November 27, 2023
I spray the the nuts with PB Blast and let them set a while. Then used a MAP gas torch to heat the nut. I did lock a pair of vise-grips near the cover of the inner tie-rod to keep the heat away from the black bellow or cover. I cam loose and this was on a 2005 Ranger that sit outside, and has been drove in Ohio salty winters for many years. I had taken a piece of cardboard from a 12 pack of pop cans and marked from the center of the tie rod, where the grease fitting would be if the original had any to the groove in the inner tie rod just inside the threaded portion. I also marked the thread before I removed the old tie rod. I put the stop nut back where it was and screwed the new tie rod on and locked to the nut. Not I re-used the old nut. When I check from the Grove it looked the same. When I drove it drove fine.
Glenn D Barker
Reviewed in Canada on September 7, 2020
Great price
Jen
Reviewed in the United States on August 20, 2019
This was a perfect fit for my explorer and I would buy again. Just be extremely careful installing the grease fitting. Putting mine in after having installed the part on the vehicle and the fitting snapped in half while installing it. It never snugged up so I wasn’t overtightening. The threads just snapped off inside the tire rod end. After some thrown tools and multiple words I can’t repeat in here, I had to take it apart and get a replacement. So I was without a vehicle for a couple of days til amazon got me a replacement, which they did. Amazon’s customer service was great. Moog has a reputation for quality so I’m just attributing this to a fluke. The other side and the replacement went in without any issues.
Bearnapper
Reviewed in Canada on February 12, 2017
Worked good on my 2000 ford explorer. Just wish it had a grease nipple that is why the 4 star rating. Better then the crappy Canadian Tire ones I purchased that lasted 6 months.
Joseph J Galat
Reviewed in Canada on October 2, 2017
So far so good.
BCr
Reviewed in Canada on July 14, 2015
the right fit, well made. Good parts.
Recommended Products
