Your cart is empty.
Your cart is empty.Package includes: 1x 1/2"-28 DIE; 1x DIE STOCK
Lukas Johnson
Reviewed in the United States on January 22, 2025
Does the job perfectly
Shotgunnkelly
Reviewed in the United States on February 20, 2024
Got this to chase the threads of a rifle barrel for a muzzle device. I have a customers rifle that we did a barrel swap on the replacement barrel threads were not right. I contacted the manufacturer who recommended chasing the threads since I could not attach a flash hider. Ordered this shipping was fast and it worked great got the job done and have a happy customer.1/2x28
b
Reviewed in the United States on October 13, 2024
Used this as part of a kit to thread a barrel. I'm not sure if it's possible to get a perfect alignment with the bore without using a lathe. The threads will still work fine for most muzzle devices, but not good enough for a can. I think reducing the O.D. with the piloted annular cutter is mostly responsible for the misalignment, at least more so than the die starter and die cutter.
MarksAlot
Reviewed in the United States on April 5, 2024
Perfect.Were what I needed to retap and rethrend
Eric
Reviewed in the United States on July 28, 2023
Tried using the common dies that come in sets bought at auto parts stores. 1/2 inch is pretty big and it's just too big for those tiny handles. I got half way into the thread and couldn't go any more. I bought this product and was amazed at how quickly I cut my threads. Ten minutes later I realized I should have gotten 1/2 20 instead of 1/2 28. That's what being in a hurry will get you. But the product worked well.
Donna LaVanway
Reviewed in the United States on May 3, 2021
I was apprehensive about doing this. It worked amazingly well but it took a lot more force than I was anticipating. I have tapped and threaded common bolt sizes and this is much larger than anything I've even done, so it may be normal. Having broke many more commonly sized taps and ruined some smaller tread jobs it was unnerving to apply that much force to a die (this is relative the amount of force was not excessive for opening a difficult jar of pickles, but for threading it seemed to be). Needless to say, it turned out great. Pro tip: USE LOTS OF CUTTING OIL
T D Jessee
Reviewed in the United States on August 14, 2020
Is much better quality than I was expecting.Cut Beautiful threads that fit my muzzle device perfectly. The only ding I can give is that both sides of the die are designed to start the cut, Not one side to start and the other to clean up the final threads as it should be. Nonetheless worked flawlessly and save me over $100 compared to a local gunsmith doing the same work.The die threads are still sharp and should cut several more times, the handle is well-made and strong and should last a long time.
Amanda R.
Reviewed in the United States on December 11, 2020
Threads are not the proper size, period. Does not fit threads on my already threaded barrel or thread alignment tool. Almost ruined my thread alignment tool trying to get it started and not even close to threading onto my factory s&w ar barrel. I will have to purchase a different one because I know that this would not work for any muzzle device.
Recommended Products
