Your cart is empty.
Your cart is empty.This speed controller has various advantages and functions, which can meet the needs of different application scenarios and provide convenience and safety guarantee for users' work. Specification: Input voltage: AC 100V-120V; Input maximum current: 15 amps; Continuous current: 8 amps; Resistive load: maximum 2000W; Inductive load: 1000W max. Notice: 1.The input of this product is AC voltage, and the output is also AC voltage, and the output voltage is the same as the input voltage, so it cannot be used as a boosting product. 2.Be cautious when using electronic products with circuit boards! 3.Please use it within the rated power and voltage range. 4.It is normal to feel a slight heat during work. 5.The above-mentioned 2000W refers to the limit power on resistive loads (such as tungsten lamps, heating wires, etc.), while inductive loads refer to the limit power of 1000W, which refers to series motors.
Randy
Reviewed in the United States on January 19, 2025
This item would not work with my motor. So I am sure if I had the correct motor it would have been fine
Guy Sicard
Reviewed in Canada on January 11, 2025
Pulled it from the box and on the back written quite large is 10 amps max, not the 15 amps advertised.
Richard Oconner
Reviewed in the United States on June 4, 2024
It worked on my 2014 Silverado and 2019 Camaro after taking them back to Sam’s club the second time to get the pressure sensor properly programmed.
Integrator
Reviewed in the United States on May 31, 2024
Motor Speed Controller AC 120V 15A Variable Adjuster. we use for aggregate dust collection so the vacuum doesn't have to scream at top RPM. nice little speed controller or rheostat for some fans lighting and more.
gary g.
Reviewed in the United States on February 15, 2024
Works good. Thank you
Timothy Haag
Reviewed in the United States on December 22, 2024
Just what I needed for my exhaust fan.
Paul D
Reviewed in Canada on November 30, 2024
Worked for three hours and then quit.
Customer
Reviewed in Canada on November 2, 2024
The heat sink in the unit got really hot and melted through the power cable causing an internal short which burned out the screen and I'm not sure if the unit is still safe to use so I don't anymore. Probably could use a better heat sink and or a small fan to keep it from overheating. Also securing the internal wire so it can't touch the heatsink could help alleviate this issue.
ycad
Reviewed in Canada on November 1, 2024
super
MYtech
Reviewed in the United States on January 31, 2024
I go to 0% turn it off, turn it back on and it will not show voltage change or start working till 40%. This happens to be okay for my needs but buyer beware
Recommended Products
