Your cart is empty.
Your cart is empty.Premium aftermarket replacement parts for Ford and Lincoln vehicles, Tested to provide performance and long-life reliability. Two-year unlimited mileage warranty, labor included and no commercial exceptions.
william eaton
Reviewed in the United States on March 17, 2025
Working great
FLEquestrian
Reviewed in the United States on May 28, 2024
Good quality and perfect fit at a great price. Arrived quickly.
WalterB
Reviewed in the United States on November 13, 2024
If you're having problems going through IPR valves and are running a aftermarket wix filter, that's your problem. Get the wix out (even if you're not having problems) and go with the factory motorcraft filter. Yes the wix is just as good as the motorcraft filtration wise but it doesn't fit the canister correctly and will allow oil to bypass unfiltered(there is a Ford TSB about this problem)
Aaron
Reviewed in the United States on April 7, 2024
Appears to be OEM. I used to KNM filter with it. Fit great. Would recommend.
DonSz
Reviewed in the United States on August 18, 2023
I had a substantial oil leak in my 2008 Ford F250 Super Duty 6.4 diesel truck. The truck has less than 69,000 miles and is primarily used to pull our 37’ 5th wheel RV. I installed the oil cap and torqued the cap. I drove about 80 miles pulling the RV. When we arrived, I couldn’t find any traces of oil leaking. I will continue to check for future leaks.
aoran
Reviewed in Canada on October 23, 2023
Made the mistake of having my oil changed at a shop and they replaced my cap and filter with an aftermarket. Then I read all the forums about not using aftermarket filters. So I am buying this to replace the one lost at the shop.
Randy Hunter
Reviewed in Canada on September 25, 2021
Works like new
Daniel S.
Reviewed in the United States on September 24, 2018
I received an authentic Motorcraft oil filter cap. If you own a 6.0 Powerstroke, it is absolutely imperative to use only authentic Motorcraft caps for the oil and fuel filter housings. Other "will fit" caps may seem the same but due to infringement laws, they cannot exactly copy the OEM parts. This leads to more oil going through the filter bypass which goes back into the engine without being filtered. On the 6.0 Powerstroke (and to a lesser degree the 7.3 Powerstroke), clean oil is directly correlated to engine longevity due to the high pressure oil pump (HPOP) system and fuel injection system, both of which are very sensitive to dirty oil.Bottom line is that do not cheap out on filters and their associated caps on the 6.0 Powerstroke!Also, this cap is the correct cap for the horizontal fuel conditioning module (HFCM) on the driver's side frame rail.
Behr
Reviewed in the United States on December 19, 2015
Works fine with Motorcraft filters. Beware of the other kind that is real tall, your filter won't work.
TJ
Reviewed in the United States on July 26, 2013
I have an 03 f350 with a 6.0, my hfcm cap(the fuel filter/pump assembly on drivers side frame rail) got damaged plastic cap nut rounded off and i needed a new one. I looked all over the net for a p/n and nothing came up. finally i stumbled across a forum that said the oil filter cap is the same as the hfcm cap on the 6.0. So i bought it, it fit good threaded on fine, no leaks, the 40 nm(18.5 ft/lb) torque spec on the cap matched the instructions for fuel filter installation, conveniently same as oil filter cap spec. It comes with a black oring for the oil filter assembly would probably work fine, but if you have it apart you probably are swapping filters anyway so they will come with the correct green oring. I would caution to either buy the oil filter socket for these caps or at least use a six point socket(36mm), don't use the 12 points since they will gradually round off the plastic.
Recommended Products
