Your cart is empty.
Your cart is empty.Motor
RM
Reviewed in the United States on March 24, 2024
After much head scratching and trying to figure out why my motor was vibrating back and forth instead of turning I checked for continuity and realized the wiring diagram is not accurate. My coils were wired to pins 1-3 and 4-6, not 1-4 and 3-6 as indicated in the diagram.Once I figured that out it has worked well and luckily it didn't burn up the driver. It's a little weaker than expected but it gets the job done for my project without skipping.
Yesid Bernal
Reviewed in the United States on December 27, 2024
The media could not be loaded.
Customer
Reviewed in the United States on September 24, 2023
Great motors, especially when paired with the right motor drivers. No problems whatsoever
Jaime
Reviewed in Mexico on August 8, 2023
Lo quiero para un proyecto escolar pero no tiene ningún dato de referencia.
Dan_g
Reviewed in the United States on January 13, 2023
Great price, all worked well. However, the pinout schematics shown on Amazon were incorrect. BE SURE TO VERIFY COIL PIN NUMBERS with a multimeter. Note that in my case, the pins were A+ A- B- B+
PeteP
Reviewed in the United States on September 4, 2022
Coils are 1-4 and 3-6 now 1-2-3 and 4-5-6 as on a Ender original motor. Don't burn out your board.With 20+ 5 star reviews, I guess I am the one learning from own mistake that the PIN-out is not STANDARD.Where on most NEMA 17 motors, Pins 1-3 and 4-6 are the two coils (with 2 and 5 as center coils, used or not), on this one you go 1-4 and 3-6 ... and the only thing that tells you that, is a diagram in the actual product page on amazon (missed it) and the fact that the wires are colored differently than the Ender's (which I didn't use since I was just changing the motor).I am silly and now I need a new board - but maybe other will avoid this issue by learning from my stupid mistake. 1 star for not showing that as clear difference.
Susie
Reviewed in the United States on September 23, 2022
Just Wanted to add the 2 motors i received were wired correct for my Anycubic Predator, i also have an Ender 3 the cable wires need to be moved around for Creality Ender ectcable came with 6pin side (red blue green black) worked for AnycubicGreen Blue Black Red for Ender(looks like some people got ones wired for ender)
RSD
Reviewed in the United States on May 12, 2022
Great up grade to allow dual drive gear on Ender 3. The original shaft of the extruder on my Ender 3 was to short to allow the set screw of the dual gear upgrade to engage so I purchased this stepper and it works flawlessly.
DopeGod_3D
Reviewed in the United States on May 11, 2022
The media could not be loaded.
Diego
Reviewed in Mexico on November 18, 2022
al inicio no me funciono usando el arnes original de mi Anet e12, pero al revisar, la polaridad de mi arnes era diferente a la de este motor, solo cambie los cables del conector y funcionò correctamente
Salvador c.
Reviewed in Mexico on November 12, 2022
Ya lo puse en su lugar y ensamblo como de ve de ser
Recommended Products
